Datalogic MEMOR K Manuale di avvio rapido - Pagina 2
Sfoglia online o scarica il pdf Manuale di avvio rapido per PDA Datalogic MEMOR K. Datalogic MEMOR K 2. Mobile computer with 1d/2d imager
Stampa la pagina
BATTERY INSTALLATION
1. Slide the battery cover switch to the unlock position (right side); lift and remove the battery
cover
2. Insert the battery pack into the slot, top first, and press it into place.
3. Insert the battery cover (bottom side first) and press it into place; slide the battery cover swi-
tch to the lock position (left side).
SD CARD INSTALLATION
We recommend the use of Single Level Cell (SLC) industrial grade microSD or microSDHC memory
cards for maximum performance and durability. Contact the sales support team to select the
memory card for your device.
NOTE: If you use your microSD/SDHC card as portable storage, format it to Fat32
before installation.
To install the memory card:
1. Remove the battery cover (see "Battery Installation", step 1).
2. Remove the battery.
3. Insert the memory card into the slot with the written part upward.
4. Replace the battery and the battery cover (see "Battery Installation", steps 3 and 4).
CHARGING INSTRUCTIONS
The battery pack is not initially fully charged. After installing the battery, charge it with the power
supply or with the single slot dock for minimum 3.5 hours.
During the charging process the charging LED positioned at the top left side of the display glows
red constantly. Once the charging process has been completed, the charging LED glows green
constantly.
NOTE: Using the device while the battery is charging will significantly increase the
time required to reach a full charge.
NOTE: The Memor K may get warm during charging. This is normal and does not
mean a malfunction.
CAUTION: Ensure all the components are before performing any type of connection to
the Memor K. Any damage caused by use of wet equipment is not covered by warranty.
Charge with the USB
Use the provided USB Type-C cable in conjunction with the power supply adapter (p/n 94ACC0316)
to charge the device from a power outlet.
CAUTION: Use only the Datalogic power supply 94ACC0316 to power the Memor K.
Charge with the Single Slot Dock
Insert the device into the dock with the screen facing front and the head facing up.
CAUTION: Use only a Datalogic approved power supply to power the single slot dock.
NOTE: For information on the single slot dock refer to the Quick Start Guide included
in the dock's box.
TURN ON/OFF THE DEVICE
To turn on the Memor K, press and hold the Power Button for at least 3 seconds.
To turn off the Memor K, press and hold the Power Button until the Reboot Options Menu appears
end then tap Power Off.
Force Restart
Press and hold the Power Button for at least 10 seconds to force restart.
SCANNING AND IMAGING
To scan a bar code symbol:
1. Point the scan window at the bar code.
2. Press one of the scan triggers. A red spot illuminates the symbol, which is captured and deco-
ded.
If the scan has been successful:
If enabled, the good read beep plays.
If enabled, the GreenSpot projects a green spot onto the bar code image.
If enabled, the good read indicator positioned at the top left side of the display glows solid green.
The decode results display on the screen.
Aiming Beam
The aiming beam is smaller when the device is closer to the barcode and larger when it is farther
from the barcode.
Scan symbols with smaller bars or elements (mil size) should be read closer to the
unit and those with larger bars or elements (mil size) should be read farther from
the unit.
Linear Bar Code