DUUN 140001 Manuale di istruzioni - Pagina 14
Sfoglia online o scarica il pdf Manuale di istruzioni per Macchine agricole DUUN 140001. DUUN 140001 16. Wood grab
Anche per DUUN 140001: Manuale di istruzioni (9 pagine)
Stampa la paginaService and maintenance
Before cleaning, lubricating, repairing or adjusting the machine, stop the engine and activate the
handbrake, and remove the key during work.
Pay special attention to safety during maintenance work, park the machine in according with
specified safety rules.
Inspection after screw connections
Screws - nuts - fittings and bolts on the machine should be re-tensioned after two hours of operation.
All moving parts should be lubricated with grease.
The ejector spout's swivel is exposed to both cold and heavy wear - therefore use cold-resistant
grease that can handle up to -40 degrees. Points 4 and 5.
Wear steel and skid pads are exposed to heavy wear - check and carry out the replacement or
reversal of wear steel before damage occurs to the hull itself and mounting brackets.
Replacement of feeder blade – replacing the feeder blade, the opposite blade must be replaced
also at the same time to stop vibrations.
To extend the life of the machine, cleaning after use is recommended. After the season, use water for
cleaning.
Remove snow after use so that icing does not cause any problems at start-up later.
Do not flush water directly into the bearing. For long-term storage, it is recommended to lubricate the
machine in acid-free oil.
Interval of lubrication and grease quality
1. Infeed wing
Interval:
Every 10. operating hours.
2. Bearings for the main axle in front of fan
Interval:
Monthly and when parking in the spring (approx. every 200 hours).
Avoid pushing in too much grease as this can cause sealing rings to squeeze out +
contribute to overheating of the entire bearing.
Recommended amount of 7-8 grams per time.
3 Bearings for main axle and in rear of fan
Interval:
Monthly and when parking in the spring (approx. every 200 hours).
Avoid pushing in too much grease as this can cause sealing rings to squeeze
out + contribute to overheating of the entire bearing.
The recommended amount of 7-8 grams per time.
4. Expiration spout for ball bearing
Interval:
Every 50 hour.
5. Sprocket for expiration spout for ball bearing
Interval:
When needed.
6. Power transmission shafts – universal joint + telescopic tube
Every 8 – 10 operating hour.
Interval:
Maintained according to the attached instruction manual. Please contact the supplier if this is
missing.
Grease quality: Universal grease of good quality.
14