ADE KWE15-IP65 Manuale operativo - Pagina 6

Sfoglia online o scarica il pdf Manuale operativo per Bilance ADE KWE15-IP65. ADE KWE15-IP65 16. Compact scale in stainless steel housing

2.10 Unit operation

When scale is on, press [TARE] for more than 3 seconds to change the weight unit between g,

kg and lbs. Requirement is a stable weight.

Selected unit will be stored, when scale is switched off.

2.11 Check weighing – Minimum and maximum values with acoustical alarm

For setting minimum and maximum values, scale has to be empty.

Now press both [SET] and [ON] together for 3 seconds.

Display will show "-no-" (in delivery condition). Press [TARE], it will circularly display "-no-",

"-in-", "-out-" and again "-no-":

„-no" deactivates the alarm function.

„-in-" activates the alarm within the range.

„-out-" activates the alarm out of the range.

When display shows "-in-" or "-out-", press [ON] to confirm the choice.

When "-in-" or "-out-" is confirmed now the minimum value can be chosen. The display shows

an arrow at "Under" and the first digit is lighting. The light shows the value set last time and the

digit which can be adjusted is blinking. Now press [SET] to change the digit, press [TARE] to

change the digit value, and press [ON] to confirm.

Then the setting of minimum value is done and the arrow at "Over" is lighting. Use the same

way to finish the setting of the maximum value.

When finished setting, it returns to weighing mode and the weighing alarm function is on.

If the weight is upper the maximum value, the "Over" indicator is lighting, while arrow to "Under"

is lighting, when weight is under minimum value.

If the weight is between minimum and maximum values the arrow next to "Accept" is lighting.

If activated (setting "-in-" or "-out-"), control weighing is supported by an acoustic signal, which

sounds, if the weight is in between or out of the minimum and maximum values (as set in the

parameter; see Cap. 3.8).

For zeroing minimum and maximum values, set both values back to 000000 or deactivate

function by choosing "–no-".

The settings will be stored in memory when scale is switched off.

If changing the weighing unit, this function will be closed and the current

setting value will be auto-cleared.

If changing the graduation, this function will be closed and the current setting

value will be cleared.

KWE-190107-Rev008-UM-en