ADE M10813 Manuale operativo - Pagina 3

Sfoglia online o scarica il pdf Manuale operativo per Bilance ADE M10813. ADE M10813 5. Mechanical sliding weight baby scale

050100-Rev001-M10813

Coarse taring

Place the scale in its working area and make sure

the ground surface is even.

In order to get the most accurate reading a proper

zero setting is absolutely necessary. To do this

place both sliding weights to ZERO position.

Indicator (hand) and counter hand must be fully in

line (see pictogram 4).

If they do not line up, the zero value has to be set.

To do this, use the tare weight. By undoing the

knurled nut (see pictogram 5) the tare weight can

be easily pushed gently to either side on the bar

until hand and counter-hand do quite accurately line

up.

Make sure to fix the knurled nut again.

The tare weight is also used to tare off the weight of

objects on the tray (e.g. a cloth).

Fine adjustment

Pictogram 6 shows the position of the fine taring

screw. Turn it either to the right or left side and Stop

doing so subject to hand and counter-hand line up

100%.

Attention:

A periodically zero setting according to the previous

instructions should be done.

This applies especially if the scale is used in a

different place, on a different surface.

Weighing

Coarse taring and fine adjustment being

done successfully the weight of the baby

may be taken.

Place the baby on the tray.

Slide the large sliding weight along to the

estimated weight of the infant.

Using the small sliding weight you may

easily determine the exact weight by sliding

it along until hand and counter-hand fully

line up.

The accurate weight of the baby is the

addition of the two weight results (bigger

and smaller sliding weight).