Afag IRG 1-S Traduzione delle istruzioni per l'uso e l'installazione - Pagina 6

Sfoglia online o scarica il pdf Traduzione delle istruzioni per l'uso e l'installazione per Controllore Afag IRG 1-S. Afag IRG 1-S 14.

2 Description of the device

Electronic controller IRG1-S for the infinitely variable regulation of magnetically driven

vibratory bowl, linear or hopper feeders.

The units operate using the phase-angle control principle to provide a variable output

voltage for the drive magnet. Feeder throughput is adjusted with a potentiometer fit-

ted in the front plate. The control range of the potentiometer can be scaled by using

internal trimmers U

min

ler can be used with vibratory feeders that have a tuned frequency of 6000 vibs/min

(7200 vibs/min) or 3000 vibs/min (3600 vibs/min) (also referred to as full and half-

wave). The running frequency can be selected by setting an internal switch (see set-

tings). An adjustable soft-start timer is provided to ensure that the feeder starts up

smoothly when the mains supply is switched on or the control input is enabled.

The controller can be enabled with a 24 Vdc signal from a PLC, for example (control-

ler runs when signal voltage is applied).

Supply voltage variations are eliminated by an internal compensation circuit so that a

constant feeder throughput is always maintained.

Miniature magnets can also be operated safely at the IRG 1-S con-

troller!

In the case of applications that require the oscillation conveyor to

be switched ON and OFF constantly (e.g. dust switching, hopper

control system, etc.), the prescribed controller input must be

used. If the load circuit is disconnected with a switch or a relay

the controller may be damaged.

If the controller is switched on, never insert or remove the plug at

the vibration conveyor being operated. This can damage the ap-

pliance.

Page 6

/ U

so that adjustment is linear from 0...100 %. The control-

max

NOTE

CAUTION

04/03/2020

R02.1