4ms Company Mini PEG Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Sintetizzatore 4ms Company Mini PEG. 4ms Company Mini PEG 12.

re-sync to the ping clock. Notice how the envelopes do not

necessarily start or end on a ping clock.

Using the Trigger Jack in Sync and Async Mode

When the Trigger jack is configured as Quantize and it receives

a trigger, the module will wait for the next divided/multiplied ping

clock before staring the envelope. See Figure 6.

When the Trigger jack is set to Async Trigger or Async Gate, an

Figure 5: Changing Div/Mult in Async Mode

envelope will begin immediately upon receiving a trigger,

regardless of whether the ping clock is firing at the same

moment. See Figure 7.

Figure 6: Quantized Trigger jack (gold)

Figure 7: Async Gate jack (gold).

In Sync mode, when Div/Mult is set to dividing and the

Cycle button is on, firing a trigger into the Trigger jack

configured as Quantize will re-start (re-phase) the

envelope on the next incoming ping clock. For example,

if Div/Mult is set to /4 then the ping clock represents

quarter notes, and we could count measures as

1-2-3-4-1-2-3-4 etc. The envelope starts on the "1",

reaches its peak on the "3" and finishes just as the next

"1" occurs. If we were to fire a trigger into the Quantize

Trigger jack somewhere in between the "2" and "3",

then the envelope would re-phase so that it starts on the

Figure 8: Re-phasing a /4 envelope.

"3". See Figure 8.

This can be useful for multi-phase outputs (e.g. Quadrature patch).

The EOF jack can be configured to output a tap tempo clock. This is done in System Mode (see

System Mode section). When configured as Tap Clock, whatever tempo you tap on the Ping jack will

be steadily output on the EOF jack. Unlike configuring the EOF jack as End-of-Rise, End-of-Fall, or

Half-Rise, the Div/Mult parameter will not affect the tempo being output on this jack. More importantly,

the tempo you tapped will continue to be output even if you are clocking the Mini PEG with an external

clock at a different tempo.

This feature allows you to use the Ping button and EOF jack as a semi-independent tap tempo sub-

module: tapping the Ping button will only change the tempo on the EOF jack and not the tempo of the

envelopes.

Clock Bus is a 1:1 clock that runs along the gate pin of the Eurorack power bus. This feature allows for

a compatible module to send a clock signal over the power bus, and for one or more modules to

synchronize to this clock. The MiniPEG, DLD, and QCD from 4ms are all capable of sending and

Page