Agri-Fab 45-02101-101 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Spreader Agri-Fab 45-02101-101. Agri-Fab 45-02101-101 12. Pro 125# broadcast spreader
Anche per Agri-Fab 45-02101-101: Manuale d'uso (12 pagine), Manuale d'uso (12 pagine)

Stampa la pagina
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
10. Assemble the (long) handle tube to the side of the
crossover tube opposite the shaft support plate, as
shown in figure 4. Fasten the handle tube to the middle
hole using the bolt, flat washer and hex lock nut which
you removed in step 9. Do not tighten yet.
IMPORTANT: DO NOT assemble the handle tube to the
side of the crossover tube where the shaft support plate is
located. When the spreader is placed in the upright position,
the handle tube must be on to the top side of the crossover
tube. Refer to figure 17 on page 9.
11. Assemble the end of a handle brace to the inside of each
leg of the hopper tube frame, using a 1/4" x 1-3/4" hex
bolt and 1/4" lock nut for each brace. See figure 4. Do
not tighten yet.
12. Assemble the other end of both handle braces to the
handle tube using a 1/4" x 1-3/4" hex bolt and 1/4" hex
lock nut. Do not tighten yet. See figure 4
13. Tighten in sequence the bolts and nuts that were
assembled in steps 10, 11 and 12.
HANDLE TUBE (LONG)
1/4" HEX
LOCKNUT
MIDDLE BOLT,
WASHER & NUT
SHAFT
SUPPORT
PLATE
CROSSOVER
TUBE
FIGURE 4
14. Assemble the leg stand tube to the handle tube (long)
15. Place the vinyl cap on the leg stand tube. See figure 5.
HEX BOLT
1/4" x 1-3/4"
FIGURE 5
16. Assemble the flow control link (the long end with the
HANDLE
17. Place the vinyl grip on the flow control arm. See figure
BRACE
HEX BOLT
1/4" x 1-3/4"
FIGURE 6
5
www.mymowerparts.com
using two 1/4" x 1-1/2" hex bolts and two 1/4" hex lock
nuts. Tighten. See figure 5.
HANDLE TUBE (LONG)
VINYL CAP
1/4" HEX
LOCK NUT
LEG
STAND
TUBE
small hole) to the flow control arm using one 1/4" x 5/8"
hex bolt and one 1/4" hex lock nut. Do not over tighten.
The flow control link must pivot freely. See figure 6.
6.
VINYL GRIP
FLOW CONTROL
LINK
1/4" HEX
LOCK NUT
SMALL HOLE
1/4" x 1-1/2"
HEX BOLTS
FLOW
CONTROL
ARM
1/4" x 5/8"
HEX BOLT