Aussie Mobi-blaster BB 400 Manuale di istruzioni per l'operatore - Pagina 5
Sfoglia online o scarica il pdf Manuale di istruzioni per l'operatore per Idropulitrice Aussie Mobi-blaster BB 400. Aussie Mobi-blaster BB 400 20. Professional high pressure water blaster
Sept 2016
B.
Supply Tank
1.
Connect low pressure hose to tap and fill the
supply tank.
2.
Note: Engine will not start if water level is below
low water cut-out.
3.
Use only clean town water.
Warning: Do not operate from tank or pond.
Doing so will cavitate the pump causing
damage. Cavitation or pump starvation is not
covered
by
warranty.
phenomenon causing vacuum pockets to form
within the pump that eventually implode under
pressure pitting the internal pump surfaces.
C.
Before starting the machine
OPERATE IN WELL VENTILATED AREAS ONLY.
1.
Ensure machine is level
2.
Turn on water supply.
3.
Pull gun trigger until water starts to flow in a
steady steam then release trigger.
D1.
Starting the engine
(for Honda , refer to engine manual for other engine
options)
Throttle ...
fully open
Choke ... closed position
Fuel value open
1.
Ensure fuel valve is open
2.
Move the choke on the engine to the closed
position. If engine is warm, move choke half-
way.
3.
Turn engine ON/OFF switch to ON
Cavitation
is
Aussie Mobi-blaster ... Operator's Instruction Manual
4.
Hold the gun trigger on.
5.
Start engine, either turn engine key or pull the
recoil starter grip lightly until resistance is felt,
then pull briskly.
6.
After engine starts, release the gun trigger and
slowly open the choke.
7.
Warm up engine for 3 minutes without load.
a
D2.
Starting the engine (Mine spec version)
Emergency stop button shown reset
Battery isolator
1.
Check the emergency stop button has been
reset.
2.
Turn on battery isolator switch.
3.
Hold the gun trigger on.
4.
Turn engine key through first to second
position.
5.
After engine starts, release the gun trigger.
6.
Warm up engine for 3 minutes without load.
KEEP THE MACHINE OUT OF MOISTURE LADEN
ATMOSPHERES
Aussie Pumps
Engine start key
5