AUSSIE ECO-CLEAN Monsoon 300 Manuale di manutenzione - Pagina 4
Sfoglia online o scarica il pdf Manuale di manutenzione per Idropulitrice AUSSIE ECO-CLEAN Monsoon 300. AUSSIE ECO-CLEAN Monsoon 300 13. Monsoon series high pressure blaster three phase models
Australian Pump Industries
WATER SUPPLY HOSE:
Use a good quality hose (not supplied) of 25mm diameter minimum.
Fasten the one end of the hose to the inlet hose connector securing using a worm drive clip. This
connection MUST be tight to avoid leaks.
Water supply can be by means of either:
$
Mains Supply
Secure the free end of the hose to your tap using a suitable tap adaptor (not supplied - available
through all good hardware and garden supply stores).
$
Syphon Fed Supply
Place the free end of the hose into a water tank or container and the pump will draw water itself.
Use a larger diameter suction hose, at least 1" diameter and no more than 2 metres long.
Water supply must be above or level with pump.
NOTE: To prevent the ingress of foreign bodies into the pump we recommend that a gauze filter (not
supplied) be fitted to the free end of the hose, before connection to pump.
HOT WATER APPLICATION
Aussie Eco-clean Monsoon & Hurricane water blasters can be used in their standard configuration with
cold or hot water up to 60 C. Using optional Hot Shot
operate with water temperatures up to 80 C.
DETERGENT FUNCTION
This machine is designed to handle non-caustic cleaning agents to improve cleaning efficiency.
1.
Push clear plastic chemical injection hose with filter assembly onto the injector nipple.
2.
Submerge the end of the hose with filter into your chemical container.
3.
Reduce pressure of machine to enable venturi system to activate: on double lance
machine adjust by control handle
4.
Allow some time for the chemical to work into the grime.
5.
Set the lance to high pressure and blast detergent and dirt from the job.
6.
Remove pick up hose from detergent bottle.
7.
Rinse detergent valve with clean water by running at low pressure.
Warning: leaving detergent in the valve can cause it to stick and malfunction.
OPERATION:
Turn on water supply. Note: Tap should be full on.
Pull the trigger to expel air from the system. Water will trickle from the end of the lance when air is
expelled.
Start the engine. (Refer to engine manual for details)
Check that there are no leaks in the line connections, pistol or power lance. Pressure begins
when the pistol trigger is squeezed.
KEEP THE MACHINE OUT OF MOISTURE LADEN ATMOSPHERES
ACCESSORIES:
Your Aussie water blaster can be used with a wide variety of optional extras to enhance performance.
To use the accessories you must first disassemble the lance. Unscrew quick coupler to unlock the
lance. The accessories can then be connected to the end of the lance assembly. If quick coupler is
not supplied it can be purchased from your local Aussie Eco-Clean Distributor.
4
Aussie Monsoon & Hurricane ... Operation & Maintenance Manual
SAFETY ... IMPORTANT
EXCESS ATOMISED MOISTURE CAN ENTER SWITCHES &
MOTOR CONNECTIONS AND OVER TIME MAY CAUSE FAILURE
(Consult Selection Guide)
seals and valves the pumps can be modified to