Agri-Fab 45-02143 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Spreader Agri-Fab 45-02143. Agri-Fab 45-02143 12. Agri-fab 100 lb. push broadcast spreader owner's manual
Stampa la paginaIMPORTANT: Do Not asssemble handle tube to same
side of crossover tube as shaft support plate.
8.
Place the long handle tube onto the crossover tube
on the side opposite from the shaft support plate.
Fasten with the bolt, flat washer and nut removed in the
previous step. See figures 4 and 5. Do not tighten at
this time.
9.
Assemble two handle braces to the inside of the hopper
frame, one on each side, using two 1/4" x 1-1/2" hex
bolts and two 1/4" nylock nuts. See figure 5. Do not
tighten at this time.
10. Assemble the other end of the two handle braces to the
long handle tube using a 1/4" x 1-1/2" hex bolt and 1/4"
nylock nut. Do not tighten at this time. See figure 5.
11. Tighten all hex lock nuts and bolts in same sequence
as assembled in steps 9 through 11. See figure 5.
HANDLE TUBE (LONG)
HEX BOLT
1/4" x 1-1/2"
1/4"
NYLOCK
NUT
MIDDLE
BOLT &
WASHER
FIGURE 5
HITCH
BRACE
HEX BOLT
1/4" x 1-1/2"
MIDDLE
NUT
CROSSOVER
TUBE
SHAFT
SUPPORT
PLATE
12. Assemble the leg stand tube to the handle tube (long)
using two 1/4" x 1-1/2" hex bolts. Secure tightly with
two 1/4" nylock nuts. See figure 6.
13. Place a vinyl cap over the end of the leg stand tube.
See figure 6.
HANDLE TUBE (LONG)
1/4"
NYLOCK
NUT
VINYL CAP
FIGURE 6
14. Assemble the flow control link (end with small hole)
to the flow control arm using a 1/4" x 1" hex bolt, a
nylon washer and a 1/4" nylock nut as shown in figure
7. Tighten carefully. The flow control link should not
be loose but should pivot with no more than slight
resistance.
FLOW CONTROL
LINK
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGURE 7
5
1/4" x 1-1/2"
HEX BOLTS
LEG STAND TUBE
FLOW
CONTROL
1/4" NYLOCK NUT
ARM