Aussie Pumps BB100 Hire Series Manuale di funzionamento e manutenzione - Pagina 5
Sfoglia online o scarica il pdf Manuale di funzionamento e manutenzione per Idropulitrice Aussie Pumps BB100 Hire Series. Aussie Pumps BB100 Hire Series 16. High pressure blasters
Stampa la pagina
June 2016
ASSEMBLY & USE
Before proceeding with assembly of your new Aussie Eco Clean high pressure blaster, check that all
parts listed below are included.
1 Gun handle assembly (A)
1 High pressure hose with pigtail wrap
1 Lance and nozzle assembly (B & C)
A.
Machine Preparation (initial start-up)
1.
Check the oil in the pump
With the machine on a level surface the oil level should
cover the red spot in the oil level sight glass on the side
of the machine. If necessary, top up with SAE 75W-90.
Do not mix different grades of oil as this may affect the
machines performance. If alternative oil is used, first
empty out oil by unscrewing drain plug in bottom of
machine.
2.
Ensure breather plug is fitted to pump.
WARNING: Before operation ensure top mounted
travel plug is replaced by breather plug. Failure to fit breather and keep clean can result in over
pressuring of oil chamber (crank case) and can blow oil seals. This will void warranty.
Additional checks on engine drive BB100
1.
Check oil level in gearbox. Note this is a separate chamber to that of the pump. Fill with SAE
75W-90 if required.
2.
Check oil level in engine and fill with proper grade oil if necessary. (Automotive detergent oil
e.g. SAE 10W-30)
3.
Check fuel level and fill if necessary. (unleaded petrol)
Aussie Safety Protection Kit
Engine drive
Unloader - factory set,
DO NOT adjust
HP hose connection
Inlet filter
Supply hose
connection
Safety valve
Thermal dump
Aussie BB Hire Series ... Operation & Maintenance Manual
Gearbox oil filler cap
(engine drive only)
Electric drive
Unloader - factory set,
DO NOT adjust
Thermal dump
Aussie Pumps
B
A
Breather plug & dip stick
Pump oil level sight glass
HP hose
connection
Supply hose connection
Inlet filter
C
5