AUSSIE TONNEAU ATB01234 Istruzioni per il montaggio - Pagina 3
Sfoglia online o scarica il pdf Istruzioni per il montaggio per Automobile Accessories AUSSIE TONNEAU ATB01234. AUSSIE TONNEAU ATB01234 4. For 2012 dmax dual cab with out head board
NOTE: All Side measurements are to be taken from the TOP INSIDE EDGE of the tub.
MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys to
Cab Chassis aluminium trays.
Drill, 4mm drill bit
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders with the
holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above and then with a
white pencil make a mark through the small holes of the hollow bar onto the solid ends. This is where you will
drill a hole to the depth of about 1-2mm (do not go any further)
2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you drilled.
Make sure you do not over tighten the grub screws
middle to give it some extra height to assist with water runoff.
BASIC TOOL REQUIRED
MULTI-FIT SUPPORT BAR CONTENTS
FITTING MULTI-FIT BAR
-
2 x grub screws
. Refit the bar. You may kink the bar in the