AUSSIE TONNEAU ATB01340 Istruzioni per il montaggio - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Automobile Accessories AUSSIE TONNEAU ATB01340. AUSSIE TONNEAU ATB01340 3. Great wall v200 / v240 dual cab with sport bar

Stampa la pagina

2.2 MULTI-FIT SUPPORT BAR CONTENTS

1 x hollow bar centrepiece

2 x solid bar end piece

2.3 FITTING MULTI-FIT BAR

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders

with the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above

and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.

This is where you will drill a hole to the depth of about 1-2mm (do not go any further)

2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you

drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may kink the bar in the

middle to give it some extra height to assist with water runoff.

2 x grub screws