Aussie Traveller COOLABAH AWNING Manuale di avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di avvio rapido per Tenda Aussie Traveller COOLABAH AWNING. Aussie Traveller COOLABAH AWNING 3.

Stampa la pagina

ADDING ANNEXE WALLS

1. Attach the windskirt to the bottom of the van using

the press studs.

2. Zip each end wall and the long front wall to the

roof. Then zip the walls together at the front

corners.

When zipping the end walls to the front wall at the

front corners, zip walls together for a distance of

approx. 200-300mm (8-12") and then reach inside

and adjust the legs up to approximately 1.8m (6').

3. Ensure the corners of the roof and wall canvas,

where zippers start, fit snugly over the end of the

outrigger bar.

4. Fit touch tape returns down the sail track on the

van wall and hook into the metal bracket beside

the arm attachment point. The touch tape faces

outwards and will match with the touch tape on

the walls and windskirt.

5. Touch tape the end walls ensuring that the very

top of the end wall is positioned at the bottom of

the container floor.

6. Adjust the leg height so that the canvas at the

bottom of the front wall is 75-100mm (3-4") off the

ground and peg down to give maximum tension on

the roof and walls.

1300 663 868 | [email protected] | aussietraveller.com.au

BRISBANE SHOWROOM: 11-15 Oasis Court, Clontarf QLD 4019 | MELBOURNE SHOWROOM: 235 Barry Road, Campbellfield VIC 3061

DISMANTLING YOUR AWNING

1. Remove the roof rafters, zip up windows and

doors and remove pegs around annexe.

2. Remove touch tape returns from sail track and

detach windskirt. Lower legs fully down and zip off

front and end walls. Fold up and store.

3. Release blind rod from behind legs, one side at a

time. Fold up legs, lower outrigger to the ground

and clip the legs into the pole clips in the outrigger.

4. Depress spring button and slide pipe sleeve off the

arm hinge and push arms in towards each other.

Ensure the arm sleeve engages over the spring

button on the arm to prevent it sliding into the

hinge section and causing damage.

5. Release the brake on the roller, fit the winder

handle to the roller shaft at the front of the

container and winding in a clockwise direction

wind the roof canvas into the container.

Keep tension on the winder handle and tighten the

brake handle to prevent the possibility of the blind

unrolling while travelling.

6. Pick up the outrigger and guide up under the

container ensuring that the arms fold up smoothly.

Clip securely into place. You may need to apply

minimal pressure to the blind rod cover in order for

the buckles to meet snugly.

Always ensure that you check that the buckles

are secured tightly before travelling.