Agri-Fab 45-03641 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Spreader Agri-Fab 45-03641. Agri-Fab 45-03641 13. 250 lb. tow broadcast spreader
Anche per Agri-Fab 45-03641: Manuale d'uso (12 pagine)

Stampa la pagina

(R) NYLON

WING NUT

(K) 5/16" FLAT

WASHER

(J) NYLON

WASHER

(S) ADJUSTABLE

STOP

(F) 1/4" x 3/4"

CARRIAGE BOLT

FIGURE 12

24. Position the ﬂ ow control mounting bracket (ﬁ gure 13).

a. Push on ﬂ ow control arm until it locks in "OFF"

position.

b. Slide ﬂ ow control mounting bracket along tube until

closure plate in bottom of hopper just closes.

c. Snug the 5/16" lock nuts just enough to hold ﬂ ow

control mounting bracket in place.

d. Set adjustable stop at "5". Pull ﬂ ow control arm

against stop. Verify that closure plate has opened

about half way.

e. If closure plate does not open half way, adjust

position of ﬂ ow control mounting bracket until

closure plate will open about half way at "5" and

will still close when arm is locked in "OFF" position.

Tighten the 5/16" lock nuts.

FLOW

CONTROL

ARM

ADJUSTABLE

STOP (S)

(SETTING "5")

FIGURE 13

25. Place the screen down into the hopper, sliding the edge

of the screen under one of the clips. Slightly bow the

screen to slide the opposite side of the screen under

the other clip. See ﬁ gure 14.

CLIP

FIGURE 14

26. Assemble the hitch bracket to the hitch extension bracket

using two 3/8" x 3/4" hex bolts (D) and 3/8" nylock hex

nuts (I). Insert the bolts from the bottom. See ﬁ gure 15.

27. Assemble the hitch pin (P) through the hitch bracket and

the hitch extension bracket and secure with the hair cotter

pin (O). See ﬁ gure 15.

(P) HITCH PIN

(O) 1/8" HAIR

COTTER PIN

FIGURE 15

SCREEN

CLIPS

(I) 3/8" NYLOCK

HEX NUT

(D) 3/8" x 3/4"

HEX BOLT