Agri-Fab 45-0350 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Carrello da esterno Agri-Fab 45-0350. Agri-Fab 45-0350 12. Atv tandem axle cart farm tandem axle cart
Anche per Agri-Fab 45-0350: Parti di ricambio (2 pagine), Manuale d'uso (12 pagine)
Stampa la pagina
10. Assemblethe front paneloverthe end of the cart
usingsix 1/4"x 1/2"hexboltsand1/4"SEMSnuts
as shown in figure 4. Leave two holes in the
bottomof the panelemptyas shown.Pullthe cart
bodyhalvestogetherandtighten the boltsin the
bottomofthe frontpanel,thentighten the boltsin
the sides. Seefigure 4.
11. Tighten the bolts assembledin step 4 to fasten
the bottomof the carttogether.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" x 1/2"
HEX BOLTS
1/4" SEMS NUT
x
&`
/
1/4" SEMS NUT
14. Assemble
the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" SEMS nuts
as shown
in figure
6. Heads
of bolts go on the
inside of the cart. Tighten.
5/16" x 3/4"
TRUSS HEAD BOLT
WHEEL
SUPPORT
\
5/16"
SEMS
NUT
FIGURE 6
FIGURE
4
12. Assemble the latch stand bracket
to the cart so that
the aligning tab is at the bottom of the bracket. Use
four 1/4" x 1/2" hex bolts and 1/4" SEMS
nuts.
Tighten.
See figure 5.
13. Assemble
a corner cap to each front corner using
one ortwo
1/4" x 1/2" hex bolts and 1/4" SEMS nuts
per cap. Leave out the rear bolt if the cart has top
rails (model 45-0350 only). TIGHTEN. See figure 5.
LATCH STAND BRACKET _ --\
(Aligning
tab at bottom)
Leave out on
Model 45-0350
/\, i! ]
FIGURE
5
15. Lower the cart to rest upside down on its top flange
with the wheel support facing up. See figure 7.
16. Lay the drawbar tongue (open side facing up) onto
the Wheel
Support
and the Latch Stand Bracket.
Slide the axle through
the wheel support
and the
tongue. See figure 7.
AXLE
DRAW BAR
TONGUE
_,i
LATCH STAND
',i
BRACKET
FIGURE 7