4RF Aprisa SR Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete 4RF Aprisa SR. 4RF Aprisa SR 2.

Stampa la pagina
5. Set up the Aprisa SR+ radio
The Aprisa SR+ has a factory default Terminal Operating Mode of
Remote Station.
One radio in the Aprisa SR+ network must be setup as a Base Station.
The other radios in the Aprisa SR+ network are setup as Remote
Stations or Repeater Stations.
Set the Ethernet Operating Mode.
Set the unique radio Network ID to be the same in your entire
network including the Base Station ID.
Set the Aprisa SR+ TX Frequency, RX Frequency, TX Power and
Channel Size to comply with your site license.
Set the Antenna Port Configuration required.
You can now configure the remaining terminal and network parameters and settings. Please refer to the Aprisa SR+ User Manual for detailed
instructions. For ACM implementations, we recommend that the Default Modulation be set to QPSK (Low Gain).
6. Monitor the Aprisa SR+ radio signal strength
When the network is installed, the radio signal strength can be monitored on
remote stations by setting the radio to Test Mode.
To enter Test Mode, press and hold the TEST button on the radio LED panel
until all the LEDs flash green (about 3 - 5 seconds).
In Test Mode, the LED Display panel presents a real time visual display of the
RSSI. This can be used to adjust the antenna for optimum signal strength.
Note: The response time is variable and can be up to 5 seconds.
To exit Test Mode, press and hold the TEST button until all the LEDs flash red
(about 3 - 5seconds).
The OK, MODE and AUX LEDs will be solid green and the TX and RX LEDs will
be solid or flash green if the network is operating correctly.
For more information, please refer to the Aprisa SR+ User Manual available from the 4RF website www.4rf.com/secure/ (login required).
Aprisa SR+ Quick Start Guide 1.4.0 © 2018 4RF Limited. All rights reserved. This document is protected by copyright belonging to 4RF Limited and may
not be reproduced or republished in whole or part in any form without the prior written permission of 4RF Limited. While every precaution has been
taken in the preparation of this literature, 4RF Limited assumes no liability or errors and omissions, or from any damages resulting from use of thi s
information. The contents and any product specifications within it are subject to revision due to ongoing product improvements and may change
without notice. Aprisa and the 4RF logo are trademarks of 4RF Limited. All other marks are the property of their respective owners.

Quick Start Guide

Aprisa SR+ Radio
Contents
Follow these steps to operate your Aprisa SR+ radio:
1.
Check the box contents
2.
Install the Aprisa SR+ radio and connect the protection earth
3.
Connect the Antenna and apply power to the Aprisa SR+ radio
4.
Connect to the Aprisa SR+ radio
5.
Set up the Aprisa SR+ radio
6.
Monitor the Aprisa SR+ radio signal strength