AUSTRALIAN MONITOR TX6000 - MANUEL 2 Manuale operativo - Pagina 4

Sfoglia online o scarica il pdf Manuale operativo per Mixer musicale AUSTRALIAN MONITOR TX6000 - MANUEL 2. AUSTRALIAN MONITOR TX6000 - MANUEL 2 6. 6 channel mic/line mixer

Stampa la pagina

Line Inputs

The TX6000 includes six dual RCA inputs for unbalanced line or aux devices such as tape recorders, video players,

tuners etc. Channel 6 has been designed to accept higher level line inputs such as CD players. When using a CD player

with the TX6000, please ensure it is plugged into the channel 6 line input. Dual RCA connectors are provided to allow

for the simple connection of domestic stereo devices such as tape desks and CD players. Both the left and right outputs

from these devices can be connected to the dual RCA's and will be summed to mono within the TX6000.

Note: Each input of the TX6000 has both a microphone and line connection. Please note that only one of these (on each

channel) should be used at the same time.

Phantom Power

The microphone inputs on the TX6000 all provide +18v DC phantom power which is required for electret microphones.If

desired, phantom power can be defeated via an internal jumper which is located on the output board near the line output

XLR socket on the rear panel (position X4 on the output board). The default setting is with the link in the 'on' position,

shorting the centre pin and the pin closest to the rear of the TX6000. To turn phantom power off, move the link to short

the centre pin and the pin closest to the front of the TX6000. Note: It is necessary to disconnect the power cord and

remove the lid from the mixer before operating this switch.

Optional Accessories

Note: The installation of some of the following optional accessories involves access to the inside of the mixer. Installa-

tion should only be attempted by a qualified technician. Always turn off the AC power and remove the AC power cord

before attempting to access the inside of the mixer.

Tone Generator Module

An optional ATC5488 4 tone generator board is available for the TX6000. This internally mounted PCB can be easily

fitted and plugs directly into a socket provided on the pre-amp circuit board inside the TX6000. The socket is located on

the front board behind the input 5 level control. Please follow the instructions supplied with the tone generator. When

any tone from the ATC5488 is activated (via contact closure) all inputs will automatically mute except for input 1. Tones

available on the ATC5488 tone generator board are:

Evacuation Tone (to Australian Standard AS2220.1.2)

Alert Tone (to Australian Standard AS2220.1.2)

Bell Tone

Pre Announce Chime

Muting Modules

Two optional VOX (signal activated) muting modules are available for the TX6000. The TX3010 mutes channels 2-6

from input 1 while the TX3014 is a dual level muting module which mutes channels 2-6 from input 1 and 3-6 from input

2. Both modules plug into a socket provided on the pre-amp circuit board inside the TX6000. The socket is located

directly behind the input 1 level control.

TX3010 Muting Module: Provides muting from channel 1 only. When activated, all other channels are muted

TX3014 Muting Module: Provides dual priority muting. Channel 1 mutes 2-6. Channel 2 mutes 3-6.

Fuse Sizes TX6000 Mixer

Mains 240 VAC: 0.5 Amperes Slow Blow