4x4 TOUGH 21-280467 Manuale d'uso - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso per Automobile Accessories 4x4 TOUGH 21-280467. 4x4 TOUGH 21-280467 16. 4wd winch

Stampa la pagina

Remote Hand Control Operation

Note:

It is recommended that for the initial set-up of the winch (prior to applying any load)

that the winch be operated in the WIRED mode.

• Before commencing any operation with the winch using the remote hand control

ensure that the isolator switch on the side of the control box is in the OFF position.

• Plug the control cable (with the remote hand controller attached) into the socket on

the control box and turn slightly anti-clockwise to lock into position.

• Turn the isolator switch to the ON position.

• Once the winch has been set-up then the remote hand control can be operated either

in the WIRED OR WIRELESS mode.

• To use the remote hand controller in the WIRELESS mode unplug the remote hand

controller from the control cable.

• If at any stage during operation the remote hand controller fails to operate the winch,

reset the control box by turning the isolator switch off then back on.

• The hand control is not waterproof and care must be taken in its usage.

In the event of damage or breakage, replacement hand controls are available to be

purchased through the 4x4 Tough customer service helpline.

Battery Replacement

The hand control is supplied with a Alkaline 23A 12V battery within the hand control and a spare battery if it requires changing.

• Keep battery out of reach of children.

CAUTION:

• If a child swallows a battery seek medical advise immediately.

• Do not use any metallic devices to install battery - this may cause a short circuit.

Figure 1.

• To open remote hand control unscrew

screws and carefully pull apart the two halves.

Receiver Component Replacement

Figure 7.

• To open control box unscrew 4

screws and carefully lift the lid.

PLEASE CONTACT THE AFTER SALES SUPPORT TEAM IF REPLACEMENT PARTS ARE REQUIRED.

Remote hand

control

Figure 2.

• To access the battery, pull o

which is inserted into the 6 recesses on the circuit board. Bend the

front of the printed panel forward. Once the battery is replaced

( en suring the polarity orientation is correct.ie: Match + to +),

put back the IN/OUT toggle switch assembly and reassemble the

hand control.

Control box

Figure 8.

• Gently lift out old Receiver Component (do not pull out by the wiring)

and unplug. Insert replacement Receiver component.

WIRED

LED indicator

LED light

power ON/OFF

Battery

Figure 3.

the IN/OUT toggle switch assembly

Figure 9.

WIRELESS

LED indicator

LED light

WIRELESS

ON/OFF switch

Cable engage/

disengage

Receiver

component