BENDIX TC-6 BRAKE VALVE Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Unità di controllo BENDIX TC-6 BRAKE VALVE. BENDIX TC-6 BRAKE VALVE 4. Trailer control brake valve

Stampa la pagina

TC-6

™

VALVE

TO FRONT

BRAKES

FIGURE 3

Position the torsion spring (8) in its approximate position in

the body so that the end which engages the handle rests

against the side of the body opposite the bracket retaining

screw holes. Place the roller cam (11) in position as shown

in Fig. 2 and insert pivot pin (13) through the torsion spring

and partially through the roller cam, leaving room to insert

the wedge shaped end of the handle.

With a small screwdriver or similar tool, force the tang of the

torsion spring towards the opposite wall of the body far

enough so the handle (10) may be inserted into the roller

cam. The pivot pin (13) may then be tapped on through

until the ends of the pin are flush with either side of the

body.

Place the mounting bracket in position and secure with two

slotted head cap screws (14).

Place the rubber knob back on the handle. Reinstall the

valve on the vehicle and test per "operating leakage checks"

in this manual.

DOUBLE CHECK VALVE

SUPPLY RESERVOIR

SERVICE LINE

TO REAR BRAKES

FRONT BRAKE

RESERVOIR

WARNING! PLEASE READ AND FOLLOW

THESE

INSTRUCTIONS

PERSONAL INJURY OR DEATH:

When working on or around a vehicle, the following

general precautions should be observed at all times.

1. Park the vehicle on a level surface, apply the

parking brakes, and always block the wheels.

Always wear safety glasses.

2. Stop the engine and remove ignition key when

working under or around the vehicle. When

working in the engine compartment, the engine

should be shut off and the ignition key should be

removed. Where circumstances require that the

engine be in operation, EXTREME CAUTION should

be used to prevent personal injury resulting from

contact with moving, rotating, leaking, heated or

electrically charged components.

3. Do not attempt to install, remove, disassemble or

assemble a component until you have read and

thoroughly understand the recommended

procedures. Use only the proper tools and observe

all precautions pertaining to use of those tools.

TP-3

VALVE

DOUBLE

CHECK

VALVE

REAR BRAKE

RESERVOIR

AVOID

™