dymax BlueWave 200 Istruzioni per l'avvio rapido

Sfoglia online o scarica il pdf Istruzioni per l'avvio rapido per Apparecchiature mediche dymax BlueWave 200. dymax BlueWave 200 2. Handheld diaphragm valve
Anche per dymax BlueWave 200: Manuale d'uso (16 pagine), Istruzioni per l'avvio rapido (2 pagine), Istruzioni per l'avvio rapido (2 pagine), Istruzioni per l'avvio rapido (2 pagine)

Remove the protective cover from the Lightguide Mount.

Insert the large end of the Lightguide into the Lightguide Mount until it snaps into place (Figure 1). Fasten the Lightguide into place by

lightly tightening the Setscrew located on the Lightguide Mount (Figure 2). A Hex Wrench is provided with the system for this purpose. The

Setscrew should be tightened gently to prevent damage to the Lightguide.

NOTE: Multi-Leg Lightguides should be balanced by rotating the Lightguide to obtain the desired UV intensity of each leg before lightly

tightening the Setscrew.

Figure 1. Insert Lightguide into Lightguide Mount

Connect the Power Cord to the Power Receptacle on the rear of the BlueWave 200. Plug the Power Cord into a grounded wall outlet.

If you will be using a Foot Pedal, connect the Foot Pedal to the Foot Pedal Connection (Figure 3) on the rear of the unit. A ground stud is

also provided on the back of the BlueWave 200 if additional grounding is desired.

Turn the Power Switch on (located on the rear of the unit) and press the "Bulb On" button (Figure 4). Allow the Bulb to warm up for 5

minutes.

The unit is ready for operation. The Shutter is opened and closed by means of the Foot Pedal.

Figure 3. Rear Connections

BlueWave

Quick Start Instructions

200 Version 3.1

Figure 2. Gently Tighten Setscrew on Lightguide

Mount with Hex Wrench

Figure 4. Front Panel Controls