dymax BlueWave 200 Istruzioni per l'avvio rapido
Sfoglia online o scarica il pdf Istruzioni per l'avvio rapido per Apparecchiature di laboratorio dymax BlueWave 200. dymax BlueWave 200 2. Handheld diaphragm valve
Anche per dymax BlueWave 200: Manuale d'uso (16 pagine), Istruzioni per l'avvio rapido (2 pagine), Istruzioni per l'avvio rapido (2 pagine), Istruzioni per l'avvio rapido (2 pagine)
Stampa la pagina1.
Remove the protective cover from the Lightguide Mount.
2.
Insert the large end of the Lightguide into the Lightguide Mount until it snaps into place (Figure 1). Fasten the Lightguide into place by lightly
tightening the Setscrew located on the Lightguide Mount (Figure 2). A Hex Wrench is provided with the system for this purpose. The Setscrew
should be tightened gently to prevent damage to the Lightguide.
NOTE: Multi-Leg Lightguides should be balanced by rotating the Lightguide to obtain the desired UV intensity of each leg before lightly tightening
the Setscrew.
Figure 1. Insert Lightguide into Lightguide Mount
3.
Connect the Power Cord to the Power Receptacle on the rear of the BlueWave 200. Plug the Power Cord into a grounded wall outlet.
4.
If you will be using a Foot Pedal, connect the Foot Pedal to the Foot Pedal Connection (Figure 3) on the rear of the unit. A ground stud is also
provided on the back of the BlueWave 200 if additional grounding is desired.
5.
Turn the Power Switch on (located on the rear of the unit) and press the "Bulb On" button (Figure 4). Allow the Bulb to warm up for 5 minutes.
6.
The unit is ready for operation. The Shutter is opened and closed by means of the Foot Pedal.
Figure 3. Rear Connections
BlueWave
200 Version 3.1
®
Quick Start Instructions
Figure 2. Gently Tighten Setscrew on Lightguide
Mount with Hex Wrench
Figure 4. Front Panel Controls