GABOR FSM-M Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Cremagliere e cavalletti GABOR FSM-M. GABOR FSM-M 20. Full swing mount

Attaching the Wall Bracket to Concrete

Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick.

If the concrete exhibits cracks or other defects, this may result in failure of the

concrete anchors and cause serious personal injury or damage to your display.

Place the wall bracket template up to the

marked locations and tape it to the wall.

Use the included bubble level to make

sure the template is level before drilling.

Use a pencil to mark the four drilling

holes for the anchor screws and then

apply a piece of tape over the marks.

3/8 in.

2.4 in.

Use a 3/8-inch (10 mm) concrete drill bit

to predrill the marked spots 2.4 inches

(60 mm) deep, and then clean out the

debris from the holes.

Remove the template, insert the

concrete anchors into the predrilled

holes, and use a hammer to tap the

anchors into the concrete.