GAC IGC700 Series Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Controllore GAC IGC700 Series. GAC IGC700 Series 18. Integral governor control

validate that the correct Security Code has been entered.

Once the correct Security Code has been entered, the Bar

Graph will begin to flash the 4-digit software version

number. If not, you must repeat this step (2).

In SETUP mode, the parameters listed under each

numeric button can be accessed by pressing the MENU

button and then pressing a Number button (See page 5).

Pressing the MENU button repeatedly will cycle through

the menus.

Do this until the appropriate LED

illuminates for the menu you want to access. You can

verify which MENU you are in by looking at the LED

Bar Graph on the left side of the front panel. Currently,

there are six MENUS to choose from. These menus

correspond to LED 0, LED 1, LED 2, LED 3, LED 4 and

LED 5 respectively.

Next, press the numeric button on the keypad for the

parameter you want to access. For example: pressing the

MENU button twice and then pressing the 5-button will

access the Overspeed parameter.

Remember that a flashing RUN/SETUP LED indicates

that you are in SETUP mode. To exit SETUP mode and

save changes to parameters, press and hold the

RUN/SETUP button until the RUN/SETUP LED stops

flashing and stays ON.

GAC recommends that the user take time to fully understand

the following items before attempting to start the engine or

going any further:

Understanding the Keypad, Menus and Parameters

(Pages 4, 5 & 6).

Understanding the LED Display Modes (Page 5 & 6).

Entering SETUP mode & Security Code.

Configuring the necessary basic parameters and saving

changes.