Gacell CT-7000 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Caricabatterie Gacell CT-7000. Gacell CT-7000 12.

button for choosing appropriate 12V Mode(s) or 24V Mode(s). One

REPAIR cycle can take up to eight (8) hours to complete the recovery

process and will enter to charge (8 steps charging cycle) when

completed. This mode uses a high charging voltage and may cause some

water loss in WET cell batteries. Plus, some batteries and electronics

may be sensitive to high charging voltages. To minimize risks, disconnect

the battery from the vehicle before using this mode.

Using 13.6V SUPPLY (Hold & Press)

This mode converts the charger to a constant voltage, constant current

DC power supply. It can be used to power 12VDC devices. Prior to use,

read your 12VDC device manual to determine if it is suitable for use with

this mode. As a power supply, it can also be used to retain a vehicle's

on-board computer settings during battery repair or replacement. 13.6V

Supply Mode provides 13.6V at 5A with overload protection at 6A (Max).

Both spark proof and reverse polarity protection are disabled in this

mode. Do NOT allow the positive and negative battery clamp or ring

terminal to touch or connect to each other as the charger could

generate sparks.

CHARGING STEPS

STEP 1: DIAGNOSIS (Check if battery has connected with the charger

and also check battery voltage)

STEP 2: DESULPHATION (If battery voltage is too low, programs

automatically generate pulsing current to remove sulphate, up to 5