AFF 3182 Manuale d'uso - Pagina 4
Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di sollevamento AFF 3182. AFF 3182 7. 2,500 lbs power train table/lift
!
OPERATING INSTRUCTIONS
1.
IMPORTANT: Become familiar with the pedal operation of the air/hydraulic foot pump before using
the lift table under load. Stepping on the PUMP end of the foot pump pedal will engage the pump and
raises the lift table under load. To raise the saddle a small distance it is necessary to use incremental
taps of your foot on the foot pedal until the saddle reaches the height. Lowering the saddle is
accomplished by depressing the RELEASE end of the foot pump.
2.
Lift the vehicle to the desired work height and support the vehicle in accordance with the
manufacturer's recommended support procedure and the warnings given in this manual.
3.
Follow the manufacturer's recommended service procedure for removing and installing the
component.
4.
When removing a transmission use an under hoist stand rated greater than the weight of the engine
before unbolting the transmission from the engine.
5.
Position the lift table directly under the component to be lifted. Connect shop air supply to the air/
hydraulic foot pump. Use minimum 90 PSI air pressure and do not exceed 120 PSI.
6.
Depress the air/hydraulic pump foot pedal marked "PUMP" to raise the lift table saddle to a height
very close to the center of balance point of the component but do not touch it.
7.
IMPORTANT: The Power Train Lift/Table is equipped with mechanical safety latches that will help hold
the unit in place at 30%, 60%, and 80% of the lift range. Refer to the parts drawing for location of the
latches.
8.
Depress the locking levers on the caster wheels to prevent the unit from moving.
9.
Using the universal table adjust the blocks to fit the component configuration. Secure the blocks to
the universal table by tightening the wingnuts under the table.
10. Adjust the tilt screws in order to align the saddle with the components lift surface. Gently raise the lift
table saddle to support the component.
11. To lower the load depress the air/hydraulic foot pump marked RELEASE and make sure the lift table's
saddle and load do not interfere with any other undercar or undertruck components, wiring, fuel lines,
brake lines, etc.
12. Follow the vehicle manufacturer's recommended service procedures and this manual's operating
instructions when reinstalling the component.
WARNING:
Ensure that you read and understand all safety
instructions and warnings before use.
Page 4