Gage Bilt GB704SH Manuale - Pagina 10

Sfoglia online o scarica il pdf Manuale per Strumenti Gage Bilt GB704SH. Gage Bilt GB704SH 13. Installation tool

HANDLE

To inspect air cylinder bore, remove base cover (744124). Any further disassembly will require removal of the manifold-handle(744303) first.

For complete disassembly, start by removing base cover (744124). Next, holding tool upright, remove four button-head cap screws (A-928).

Lift manifold-handle (744303) from handle assy (744129) and set aside o'ring (S832) and gasket (704129). Empty all hydraulic oil into an

approved container and dispose of in accordance with all environmental regulations applicable in your area. Place piston rod wrench

(704149) down into top of power cylinder (743131), into the hex of piston rod assy. (744136). While holding this wrench, remove flexlock nut

(400559) using a 7/16" socket wrench. Still holding piston rod wrench, remove air piston assy (744121) using packing plug wrench (704150),

by turning counterclockwise. When air piston assy (744121) is completely free from piston rod assy (744136), tap or push on the piston rod

wrench to eject air piston assy (744121) from bottom of handle assy (744129). After removal of air piston assy (744121), slide piston rod assy

(744136) back up to the end of its travel. Using packing plug wrench (704150) remove packing plug (744118). With packing plug removed,

power cylinder (743131) can be removed by pushing on power cylinder tool (704151) when inserted into top of power cylinder.

To reassemble the handle assy (744129), reverse the above procedure, being certain that all o'rings are properly lubricated before installation.

Torque packing plug (744118) to 45 foot lbs. Attach the seal guide (704152) to the piston rod assy (744136) and tap the piston rod assy

(744136) through the packing plug (744118). Attach air piston assy (744121) and flexlock nut (400559) torque flexlock nut to 40 inch lbs. With

the piston rod assy (744136) in the down position, fill oil passage on top of handle assy (744129) with automatic transmission oil, Dexron III or

equivalent, when looking at top of handle assy (744129) the oil passage is the hole that has a counterbore for o'ring (S832). Replace gasket

(704129) and o'ring (S832), just prior to replacing manifold-handle (744303). (See Filling & Bleeding instructions)

AIR VALVE

WARNING:

To disassemble, first disconnect tool from its air source.

into end of valve plug (744142) and pull it out. Using the same procedure, pull out valve spool assy (744140). NOTE: It should never

be necessary to remove valve sleeve (744138) unless the ports in the valve sleeve (744138) are plugged from contaminated air. If

ports are plugged, use needle nose pliers to grasp end of spring (744144), turning clockwise and pulling to dislodge from groove in

casting. NOTE: Valve spring installation tool (744151) will facilitate the proper installation of the spring (744144), valve sleeve (744138)

can be pulled out using valve sleeve removal tool (744152).

GB704SH S/N: 1089 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

Disconnect tool from its air source before disassembly.

Remove pin (744149) and muffler (744143). Insert valve extractor (S1178)

Rev 3/15