Active Silicon AS-CAM-18HDMI4K-A Manuale di avvio rapido - Pagina 5

Sfoglia online o scarica il pdf Manuale di avvio rapido per Fotocamera digitale Active Silicon AS-CAM-18HDMI4K-A. Active Silicon AS-CAM-18HDMI4K-A 9.

Mounting the Harrier 18x HDMI 4K Camera Evaluation Board onto

the camera

The evaluation board can be mounted on the back of the camera as shown in figure 3.

To mount the board please follow these instructions:

1. Get the mounting pillars. Two of the mounting pillars are slightly shorter than the other two.

At the back of the camera, you will see two threaded holes on the left-hand side.

Screw the shorter mounting pillars into these threaded holes.

2. At the back of the camera on the right-hand side, there are two screws that secure the

casing. Remove these screws with a small cross-headed screwdriver.

Store them safely in case you want to remove the evaluation board at a future date.

3. Screw the longer mounting pillars into the two threaded holes where the cross-headed

screws were.

4. If not already connected, carefully connect the 30-way KEL cable (J2) and the 24-way FFC

(J3) to the evaluation board.

5. Carefully connect the 24-way FFC cable to the FFC connector on the camera (J302).

6. Carefully connect the 30-way KEL cable to the KEL connector on the camera (J301).

It may be helpful to add a 360 degree twist to the KEL cable before connecting to the camera

as this helps the cable to coil up compactly when mounting the board on the camera.

7. Being careful not to damage the cables, align the board with the mounting pillars and insert

the screws to secure the board (see figure 3). Ensure that the cables fit neatly between the

board and the camera.

8. To use the HDMI interface carefully remove the protective insert from the HDMI socket (J4).

September 2021

HARRIER 18x AF-ZOOM HMDI 4K CAMERA

QUICK START GUIDE

Version 1.0.0 - September 2021

Page 5 of 9