Gage Bilt GB704 Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Strumenti per rivetti Gage Bilt GB704. Gage Bilt GB704 14. Installation tool
Anche per Gage Bilt GB704: Manuale di installazione (13 pagine), Manuale di istruzioni originale (20 pagine)

Stampa la pagina

HOW TO USE THE GB704SR

WARNING:

Operator

WARNING:

It is required that eye protection and hearing protection be worn during operation.

WARNING:

Do not pull rivet in the air. Personal injury from fastener ejecting may occur.

WARNING:

Air is exhausted from the bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other

persons working in the vicinity, foreign matter and liquid.

CAUTION:

Do not use beyond the design intent.

The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept end-user air

hose fitting. The tool comes with oil and is ready to use.

1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.

2. Attach Deflector (200232) to rear of Head Cylinder Assy (704183).

WARNING:

Rotate deflector away from operator and other persons working in the vicinity.

3. Connect air hose with 90 psi. (6.2 bar) to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i. (6.2 bar) is recommended) and

cycle tool a few times by depressing and releasing lever assy (724017) (Clean dry air is mandatory).

WARNING:

Ensure air hose is securely connected to avoid possible hose whipping.

4. Disconnect air hose from tool.

5. Select proper Nose Assembly, screw collet and anvil onto the tool and attach securely. (See proper data sheet for further

instructions.)

6. Connect air supply.

7. Insert rivet into Nose Assembly and the application then depress lever assy (724017). Upon releasing the lever assy (724017), the

stem will eject to the rear of the tool.

WARNING:

Always disconnect air supply when tool is not in use to prevent accidental start-up.

S/N: 1090 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

MUST

read and understand all warnings and cautions.

Image may not reflect actual tool

Rev. 11/14