Dyna-Glo WK11C8 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Riscaldatore Dyna-Glo WK11C8. Dyna-Glo WK11C8 19. Portable kerosene-heater
Anche per Dyna-Glo WK11C8: Manuale d'uso (18 pagine)

Stampa la pagina

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

WICK ASSEMBLY- Check at least once a month!!

The burner assembly sits on top of the wick guide. Over time, tar deposits can

accumulate on the wick guide, and this can prevent the burner assemby from

seating properly. This can result in poor combustion, smoke, odor, etc.. To prevent

this from happening, tar deposits on the wick guide can be removed as follows:

Making sure that the heater is both cool and turned off, lower the wick to the "off" position.

Remove the batteries (located at the rear of the heater).

Remove the 2 guard bracket by removing 4 screws and lift off the grill assembly

as shown in illustration. (Fig. A)

Remove burner charnber.

Using the wick adjuster knob, raise the top of the wick until it is even with the top

of the wick guide. Using a flat-edge screwdriver, scrape off the tar deposits.

Be careful not to allow any of the tar deposits to drop into the grooves of the wick

guide. A small vacuum cleaner can be used to remove the tar deposits that have

been scraped off (Fig.B).

Reassemble the heater and replace the batteries.

WICK REPLACEMENT

The wick in your heater needs replacing if, after repeated cleanings, any of the following conditions still exist: slow to light,

hard movement of the wick adjuster knob, kerosene odor while burning, low heat output, slow warm up, damaged wick.

Use only a genuine replacement wick.

If cleaning the Wick does not improve performance, you will need to replace the Wick Refer to the "TROUBLE

SHOOTING GUIDE", see page 14. which outlines conditions under which the Wick should be replaced.

CAUTION : Use ONLY a genuine Replacement Wick. DO NOT attempt to substitute any other type of Wick device

or a Wick designed for another brand or model heater You could damage the heater and create a potential fire

hazard.

Call customer service at 1-877-447-4768, to order wick.

ATTENTION : The only tools needed to replace the Wick are :

A Pair of Pliers

. Push down the manual shut-off

Knob and turn the Wick

Adjustment Knob

COUNTERCLOCKWISE in the

direction of "OFF".

A Cross Screwdriver

. Use screwdriver to loosen and

remove 3 screws that fix cabinet

base to fuel tank. Remove the

Wick-Adjuster Knob and Ignition

Knob.

Fig.A

Fig.B

A Plastic Bag with a Twist Tie

. Tilt slightly and lift up the Cabinet

& Grill assembly using both hands

and lift away from the heater.