6K Products 21G36 Manuale di funzionamento e parti di ricambio - Pagina 8

Sfoglia online o scarica il pdf Manuale di funzionamento e parti di ricambio per Sega 6K Products 21G36. 6K Products 21G36 14. Simple saw system

Sprocket Removal and Replacement

The chain saw sprocket is connected to the shaft with a tapered bushing. To remove the sprocket remove the Cap

Screws (Fig. 6, Item 3) and screw them into the Threaded Holes, tighten up to 36 inch pounds to push the Sprocket

(Fig. 6, Item 1) off the Bushing (Fig. 6, Item 2). You may need to tap the Sprocket towards the motor with a hammer

to assist in getting the Sprocket loose from the Bushing. Lightly drive a flat blade screwdriver into the slot of the

Bushing.

Fig. 6

Pry between the Bushing and the Sprocket to get the Bushing off the shaft. Watch that the Drive Key (Fig. 6, item 4)

does not get lost.

To install the Sprocket, slide the Sprocket (Fig. 6, item 1) over the motor shaft, slide the Bushing (Fig. 6, item 2) onto

the shaft with the Drive Key (Fig. 6, item 4) aligned. Position the sprocket groove offset towards the motor about the

width of the bar groove with the Bushing just contacting the Sprocket. Insert the Cap Screws (Fig. 6, item 3) through

the large hole in the Bushing and screw them into the threaded holes of the Sprocket. Torque the Cap Screws (Fig. 6,

item 3) to 36 inch pounds. Check to make sure the sprocket groove is aligned with the bar groove. If the alignment is

not correct, remove and replace the sprocket and bushing and adjust the position before tightening the cap screws.