Dynablast CRDET Series Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Idropulitrice Dynablast CRDET Series. Dynablast CRDET Series 12.
Stampa la pagina
STORAGE, WINTERIZING & TRANSPORT
STORAGE
CAUTION: Always follow the proper Shutdown
Instructions on page 6 before storing the pressure washer
or accessories. For your own safety, be sure to turn the
engine OFF and discharge the residual pressure (see
page 6.)
Always store your pressure washer in a location where the
temperature will NOT fall below 0˚C. Store the machine
and accessories in a dry place, protected from freezing.
The machine should NOT be placed near an open flame
i.e. furnace, hot water heater, etc.
WARNING! The pressure washer pump is
susceptible to permanent damage if frozen.
Damage as a result of the unit freezing is NOT
covered by the warranty.
WINTERIZING
Always store your pressure washer in a location where the
temperature will NOT fall below 0˚C.
CAUTION: Always remove gasoline from the engine if
storing the pressure washer indoors.
If you must store your pressure washer in a location
where the temperature is below 0˚C, you can minimize
the chance of damage to your machine by utilizing the
following procedure:
1.
Disconnect and drain all hoses.
2.
Turn your engine/ motor on for a short period of
time until all water in the pump exits the outlet
fittings of the pump.
3.
Using a short piece of hose with a male garden
hose filling, attach it to the inlet fitting on the pump.
Making sure to hose is upright, fill it with a 50/50
mixture of automotive coolant anti-freeze and
water. Keep the hose upright and turn the pump
BASIC MAINTENANCE
IMPORTANT: Always follow the Shutdown Instructions on page 6 before working on the pressure washer or the
accessories. For your own safety, be sure to turn the engine OFF and discharge the residual pressure (see page 6)
before carrying out any maintenance.
NOZZLE
Clogging off the nozzle causes pump pressure to pulsate
and a distorted spray pattern can result.
Cleaning is immediately required with unit turned OFF.
CAUTION: Failure to discharge the residual pressure
could result in personal injury due to discharge of high-
pressure water.
Step 1: Disconnect the nozzle from the lance.
Step 2: Flush the nozzle backwards with water.
Step 3: Reconnect the nozzle to the lance.
Restart the pressure washer and depress the trigger on the
spray gun. If the nozzle is still plugged, repeat steps 1
through 3.
on for a short period of time until the pump outlet
"spits" out anti-freeze. When the outlet fitting spits
out the anti-freeze soloution, it has been evenly
distributed throughout the pump and it can now be
shut down. Your unit is not protected from freezing.
The plumbing anti-freeze will help protect against
freezing during storage and help prevent the pistons
from sticking.
TRANSPORT
Turn off fuel valve before storing or transporting
machine. Before transport, make sure that the unit is not
under pressure and that the unit is in a secure and upright
position.
CAUTION: Investigate and abide by your local laws in
the transportation of engines with gasoline in them.
CAUTION: If gasoline is left in the engine during the
winter months, the gasoline can go bad and even damage
the engine's carburetor. Please see Honda manual for
long term storage recommendations.
CONNECTIONS
Connections on hoses, the gun and spray lance should be
cleaned regularly.
COOLING SYSTEM
The air vents, located in and around the pressure washer,
must be kept clean and free of any obstructions to ensure
proper air-cooling of the motor during operation.
*ELECTRIC MODELS ONLY*
7