Hi-Force HPP21014 Manuale di istruzioni per l'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Pompa dell'acqua Hi-Force HPP21014. Hi-Force HPP21014 16. Petrol driven hydraulic pumps

Stampa la pagina

5.1 Before First Use

1. Immediately after unpacking, examine the pump for signs of transit damage and if found contact the

shipping company.

2. Remove the temporary transit fitting / plate which is fitted in the position of the oil filler breather cap

(8) and fit the oil filler breather cap which is packed separately.

3. Establish the oil level in the oil reservoir using the level gauges (2). Depending on the shipping

method used, the reservoir may either be supplied full or empty. If the reservoir is empty, it must be

correctly filled before use (See section 5.4). If the pump was supplied full of oil, no further action is

required.

IMPORTANT:

CAUTION:

Ensure the oil level does not fall below the minimum level as shown by the lower

indicator (2).

4. Remove the steel or plastic hexagon headed plugs and make hydraulic connections to the service

ports (3). These ports have a 3/8" NPT female thread and the corresponding male connections

should be wrapped with PTFE tape or other suitable sealant.

NOTE: On a pump equipped with a 3-way valve the service port is the one on the right-hand side,

when viewed from the front. (See figure 4.1).

5. Ensure the lever of the hydraulic directional control valve (4) is set to the neutral position: This is fully

anti-clockwise for models with a 2-way valve, or the central position for models with a 3-way or

4-way valve.

NOTE: Where valves are remotely mounted, make sure they are adjusted such that pressure will not

build up during the starting operation. See section 8 for applicable models.

CAUTION:

Running the pump with the motor turning in the incorrect direction may damage the low-

pressure pump unit.

6. Check engine oil level by means of the dipstick located under the engine oil filler cap (11). Top up

as necessary.

7. Fill fuel tank with unleaded petrol (gasoline) via filler cap (10).

5.0 Installation/Setup

Running the pump without oil will result in damage.

Operating Instruction Manual:

OM-HPP-01

From Serial Number:

ALL