Gaggenau CE 481 Manuale di istruzioni - Pagina 18

Sfoglia online o scarica il pdf Manuale di istruzioni per Piano di cottura Gaggenau CE 481. Gaggenau CE 481 20. Glass ceramic cooktop

Stampa la pagina

Rectifying minor faults yourself

Faults often have simple explanations. Please read the

following notes before calling the after-sales service.

Fault

The hob does not work.

You cannot switch the hob on. The main

switch flashes repeatedly when you touch

it.

The hob works, but the cooking zones do

not heat up. A dot lights up on the timer

display.

The hob has switched itself off.

"§ display and numbers

Alternating • and ˆ display

• display

"‚ display

"... display

"ˆ display

Measure

Check the household fuse for the appliance. Check whether there is a power cut

by trying other electronic appliances.

There is an object on one of the touch keys (e.g. a tea towel). Remove the object

and switch the hob on as usual.

The appliance is in demonstration mode after it is first connected. Disconnect

the appliance from the mains at the household fuse for at least 10 seconds.

Reconnect the appliance to the mains and carry out the following steps within 3

minutes:

1 Switch on the hob at the # main switch. The timer must be switched off.

2 Press and hold the @ symbol. In addition, touch the # main switch within 3

seconds.

The hob switches off.

3 Take your finger away from the @ symbol.

4 Take your finger away from the main switch.

An audible signal sounds. The dot on the timer display goes out.

The main switch was touched accidentally. You can now switch the hob on

again.

A cooking zone was operating without interruption for too long. The safety shut-

off was activated. You can switch the cooking zone on again.

There is a fault in the electronics. Switch the appliance off and back on again

using either the household fuse or the circuit breaker in the fuse box (reset). If

the display appears again, disconnect the appliance from the mains using the

household fuse. Contact the after-sales service.

A cooking zone that was set to heat setting 8 or 9 is too hot. The power for this

cooking zone was reduced to heat setting 7. When • goes out, you can set the

cooking zone to a higher setting again.

The appliance is too hot and a cooking zone has switched itself off. Remove the

pot from the heat. • goes out once the cooking zones have cooled down suffi-

ciently.

Wait a few minutes until the cooking zones have cooled down. If • appears

again after switching on, the hob is still too hot. Switch off the cooking zones

and allow them to continue to cool down.

Electronics fault in one of the cooking zones

Switch the appliance off and, after a few minutes, back on again using either the

household fuse or the circuit breaker in the fuse box (reset). If the display

appears again, disconnect the appliance from the mains using the household

fuse. Call the after-sales service.

The control panel is too hot and the appliance has switched itself off. Check

whether there is a hot pan on the control panel.

Remove the pan from the control panel. Wait a few minutes until the control unit

has cooled down. If "... appears again after switching on, disconnect the appli-

ance from the mains using the household fuse. Call the after-sales service.

The frying sensor is faulty. Acknowledge the fault message by touching a touch

key. Call the after-sales service. It is possible to cook without the frying-sensor

function.