6K Products DH0610 Manuale di funzionamento e parti di ricambio - Pagina 6
Sfoglia online o scarica il pdf Manuale di funzionamento e parti di ricambio per Motosega 6K Products DH0610. 6K Products DH0610 17. Connect and cut hydraulic chain
Stampa la paginaThe return hose can be #12 or 3/4" diameter for the first two feet, if a longer hose is required it must be #16 or 1"
up to twenty feet. If the total return hose length is greater than thirty three feet #20 or 1 1/4" hose should be used.
The filter must be rated for 40 GPM plus any additional pump flowing into it. The saw motor should run between
4000 RPM and 5500 RPM. At this speed the pressure at the return to filter connection should not exceed 80 psi
when the saw motor is running. We do not recommend using quick disconnects but if you choose to use quick
disconnects in the tank line, first consult the manufacture to determine the correct size to keep the back pressure
low enough in cold temperatures. Failure to properly size the hose and filter or properly connect the return hose to
a filter and tank will shorten the motor shaft seal life and will not be covered by warranty.
Chain Tension and Sharpening
Figure 6 shows the chain tensioning screw. A #2 or #3 Phillips screwdriver is required to turn the tension screw. With
the supplied saw bar, correct tension is when the cutters come off the rails roughly 1/8" with a tug of finger
pressure. Refer to the Oregon Mechanical Timber Harvesting Handbook for more tensioning information and
sharpening information.
Fig. 6
6