Gaggenau KG 291 CA Manuale di funzionamento e installazione - Pagina 15
Sfoglia online o scarica il pdf Manuale di funzionamento e installazione per Piano di cottura Gaggenau KG 291 CA. Gaggenau KG 291 CA 18. Gaggenau gas cooktop brochure
Anche per Gaggenau KG 291 CA: Specifiche tecniche (1 pagine)
Stampa la pagina
Do not use scouring agents, abrasives or chemically
aggressive cleaners (for example oven cleaner)!
Do not use any nitro polishing agents for cleaning!
Do not use any abrasive sponges either.
Before cleaning, please wait until the cooktop
has cooled to hand-warm.
• First lift one of the pot grids on the side with both
hands (be careful not to scratch the base). Then
remove the remaining two pot grids.
• Remove the burner head cover, the burner ring
and the burner head.
• Important! Only clean the burner parts when
cold!
Part / Material
Control Panel
(anodized
aluminum)
Control Knobs
(mat chromium
plated )
Suggested Cleaning Procedure
Use cloth with detergent and hot water.
Remove greasy splashes with a
commercially available cleaner for
aluminum. Make sure the cleaning
agent will not scratch the surface.
Use cloth with detergent and hot water.
• Soak burnt-in remainders in a little water and
detergent. This loosens even the most stubborn of
soiling. Do not use any abrasive agents and
abrasive sponges.
• Only use very little water to clean your cooktop.
Be careful that no water enters the burner base.
• As the result of heat development, slight dis-
coloration can appear on the stainless steel
surface. Do not attempt to scrape away such
discoloration. This damages the surface.
Distribute stainless steel care agents uniformly
and thinly on the hob (not on the control panel!).
This will ensure an even surface and will keep
your hob in a good condition for a long period of
time.
• Make sure the burner parts are dry before
assembly. Only operate the appliance with all
parts dry. Damp burner parts will cause
malfunctions when igniting or unstable flames.
• When assembling the burner parts, make sure
that the burner ring and burner head are placed in
such a way that the locking lugs fit in the
corresponding recesses.
• Important! Fit the middle pot support first
(be careful to center it over the burner) and
then the pot supports on the side. The
rounded corners of the pot supports on the
side must face out to the side.
Important Reminders
Do not use strongly alkaline cleaning
agents. These cleaners may cause
permanent discoloration!
Do not clean in a dishwasher.
see next page
13