ACTIVE STATION ASWD2001 Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Tapis roulant ACTIVE STATION ASWD2001. ACTIVE STATION ASWD2001 15.

Error

Cause

code

E0C

Burst clash

1. We suggest that you cut off power for 10 minutes after an extended walking period

2. The belt is too loose if it slips during use when you apply forward pressure on it.

3. If the belt is too tight, it would affect the performance of motor and increase the abrasion of roller

and belt.

4. When properly tightened, the belt can be lifted about 2"‐3" from

the deck.

Center the running belt

1. Place treadmill on a level surface and run at full speed. If the belt

drifts to the right, pull out the switch, turn the right adjusting bolt

1/4 turn clockwise, then start running until centering the belt.

PICTURE ‐ A

2. If the belt drifts to the left, pull out the switch, turn the left

adjusting bolt 1/4 turn clockwise, then start running until centering

the belt. PICTURE ‐ B

3. Tighten the belt if loosened after a period of use by pulling the

safety switch and turning the left and right adjusting bolt 1/4 turn

clockwise, re‐start the treadmill. Repeat until adequate tightness is

achieved PICTURE ‐ C

Checking

2. Check if the sensor wire of

the emergency switch is

damaged.

3. Check if the port of the

emergency switch is

damaged.

The controller is damaged.

BELT ADJUSTMENT

~ 13 ~

Correction

2. Change to the new sensor

wire of the emergency switch.

3. Change to a new console.

Change to a new controller.