Great Lakes Case & Cabinet VCM5-FO Manuale di istruzioni per l'installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Unità di controllo Great Lakes Case & Cabinet VCM5-FO. Great Lakes Case & Cabinet VCM5-FO 8. 5" vertical cable management & accessories

Stampa la pagina

INSTRUCTIONS FOR BRACKET SET A2

1. Remove bracket set A1. Based on

the rack that is being used, determine

if the VCM will mount to the front or

rear of the upright. Front or rear mounting

will determine correct orientation of

bracket set A2 (see page 5 for details).

Once orientation is determined, secure the

brackets (2 per each 40" section) to the VCM

by using the supplied #8-32 screws (Figure 3).

Verify bracket is securely fastened into place.

NOTE: All provided brackets must be installed

on the same side of the channel.

2. Hold the first channel section in the desired location of the

equipment rack, align the bracket to the appropriate mounting

holes located on either the front/back side of the rack.

3. To secure the channel section, screw the supplied #12-24

screws through the mounting bracket into the desired holes in the

equipment rack and tighten.

NOTE: Use cage nut hardware supplied with your square hole

uprights for those applications.

4. To mount the second section, carefully align the

tabs on the two sections (Figure 4) and attach

to the upright.

5. Snap the supplied covers on the

pre-determined fingers for cable security and

to maintain a clean installation.

NOTE: The channel fingers can be bent outward

and snapped off to more easily run cables from the

vertical to the horizontal channel.

OPTIONAL MOUNTING:

Connect the top and bottom of the cable management section.

Install all 4 mounting brackets. Next hold up to rack and pencil

mark the holes you need to secure VCM5F* to rack. Remove the

brackets and install them unto the rack. Finally attach to cable

management to rack by using #12-24 screws.

#12-24

FIGURE 3

VCM

FIGURE 4

#8-32