Gaggenau AI 541-720 Manuale di istruzioni per l'uso e il montaggio - Pagina 17

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso e il montaggio per Cappa di ventilazione Gaggenau AI 541-720. Gaggenau AI 541-720 20. Freely suspended insular hood

Stampa la pagina

1. Technical Data

Fig. 19

Fig. 20

Circulating air mode only

Fig. 21

Note:

the extractor hood is to be installed to a kitchen

ceiling or suspended ceiling. Ensure that the

ceiling is capable of providing a firm hold for a

maximum weight of hood and accessories of 45 kg.

Before marking the securing holes, make sure that

no electricity wires or water pipes or other wires/

pipes are laid at the drilling points in the ceiling.

Before installation check the enclosed wall plugs

and screws are suitable for your ceiling. If

necessary use special wall plugs.

Installation of the extractor hood:

Using the drilling template mark the position of

the screws on the ceiling.

2. Drill 4 holes Ø 8 mm for the wall plugs. Push the

plugs flush with the ceiling (Fig. 19).

Turn two screws to a 10 mm gap. Both screws

are placed in a position, in which at a later stage

of the installation the key-holes of the supporting

frame are found (namely back left and front

right from the control panel of the hood).

4. Adjust the support frame to the desired height

and secure with 8 screws (12 screws for the

longer ventilation ducts). The length of the

support frame can be adjusted in steps of

20 mm (Fig. 20).

Note:

this hood has been approved for installations as

low as 30 ´ ´ and as high as 36 ´ ´ above the

cooktop.

Circulating air mode

brackets, which fix the circulating air switch module

to the top of the support frame. These should be

bent outward in a 90° angle (Fig. 21).

only:

there are four