Active Tools CoxOrb Cobalt Manuale d'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso per Monitor Active Tools CoxOrb Cobalt. Active Tools CoxOrb Cobalt 4.
Stampa la paginaSelecting Work
Piece to View
Reviewing Work
Piece
Erasing Work Piece
Exiting Recall
Battery Life
Charging
Full Charge
Changing the
Battery
Press INCREASE / DECREASE VOLUME buttons.
Work Pieces are labelled with the Time of Day they
were recorded. The highlighted work piece will flash
and if you leave it highlighted for more than 3 second
it will be selected. The unit will store 20 work pieces
and after that it will automatically delete the oldest
one when a new one is recorded.
Press INCREASE / DECREASE VOLUME buttons.
The stored information can be reviewed in 5 second,
30 second and 1 minute increments depending on the
length of button press.
SPLIT/CLR cycles through recorded splits, including
the start and end of each Work Piece.
The 'Volume Level Indicator' shows the approximate
location within each Work Piece.
Press & hold SPLIT/CLR for 5 seconds when on the
work piece you wish to remove.
The screen will flash ERASE when preparing to erase
and ERASED when complete.
Press RECALL.
Unit will return to home screen and be in 'STOP' mode.
Battery & Charging
Battery Level Indicator.
Each bar represents approximately 20% of battery life
and a full battery gives around 6 hours of normal use.
Connect the charger to the Audio/Charging
connector.
The battery takes approximately 3 hours to fully
charge from empty.
During the last 5-10mins of charging your unit will
occasionally complete a memory clean up and during
this process it is not usable. When memory clean up is in
progress the unit will display 'MEM' .
When the unit is fully charged the backlight will turn
off and 'Full' will appear.
Locate and press the dimple on the battery pack, twist
anti-clockwise and gently pull the pack off.
Reverse these steps to replace the pack.