Gaggenau SP 483 Manuale di istruzioni per l'uso e il montaggio - Pagina 15

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso e il montaggio per Piano cottura Gaggenau SP 483. Gaggenau SP 483 19. Electronic glass-ceramic hob with control panel

Stampa la pagina

9. Installation

Technical Data

Total connected load: 8680 W

Important notes on installation

Pay attention to the "Important notes" on page

3 and 4.

The appliance must only be connected by an

authorised specialist, paying attention to the

relevant regulations of the power supply companies

and the regional construction regulations.

The installation technician is responsible for the

correct functioning of the appliance at the place of

installation. He must instruct the user on how to

disconnect the appliance from electricity in an

emergency.

If the range is not installed over a built-in cooker,

protection against hazardous contact from below

must be ensured after assembly, e.g. by installing

an intermediate shelf that can only be detached

using a tool. The distance between the interme-

diate shelf and the worktop in which the range is

recessed must be at least 145 mm.

There must be a gap of at least 20 mm at each side

between the appliance and any flammable walls or

furnishings.

If all poles of the appliances cannot be isolated

from the mains by removing an accessible plug, an

isolating device with a contact gap of at least 3 mm

must be installed (e.g. domestic fuse).

No warranty claims can be lodged for any

damage resulting from failure to observe these

instructions.

Subject to technical change without notice.

Electrical connection

The appliance must only be connected by an

authorised specialist.

All corresponding regulations must be observed.

The mains connecting cable must at least

correspond to type H 05 VV-F .

Note for single phase connection:

This device is intended for the connection to a

power supply system with a maximum permissible

system impedance Z

max

point (power service box) of the user's supply.

The user has to ensure that this device is

connected only to a power supply system which

fulfills the requirement above. If necessary, the user

can the ask the public power supply company for

the system impedance at the interface point.

Pay attention to the data on the rating plate. The

appliance must be properly grounded. Connect the

connecting cable to the mains.

When connecting electrical appliances in the

proximity of cooking surfaces, make sure that

connecting cables do not come into contact with hot

cooking surfaces.

This appliance may be installed in kitchen

combinations made of wood or similar combustible

materials without taking additional measures.

The built-in furniture and worktop where the

appliance is installed must be heat resistant up to

temperatures of 200° F/90° C.

of 0.46 Ohm at the interface