Dynabrade 51813 Sicurezza, funzionamento e manutenzione - Pagina 3
Sfoglia online o scarica il pdf Sicurezza, funzionamento e manutenzione per Smerigliatrice Dynabrade 51813. Dynabrade 51813 8. 100,000 rpm pencil grinder
Stampa la pagina
Handling and Storage:
• Protect tool inlet from debris.
• DO NOT carry tool by air hose.
• DO NOT force grinding swarf into the tool with compressed air; specifically avoid the pin wrench hole and front bearing areas.
• Protect abrasive accessories from exposure to water, solvents, high humidity, freezing temperature and extreme temperature changes.
• Store accessories in protective racks or compartments to prevent damage.
Filter
90 PSIG
(6.2 Bar)
• Dynabrade Air Power Tools are designed to
operate at 90 PSIG (6.2 Bar/620 kPa) maximum
air pressure at the tool inlet, when the tool is
running. Use recommended regulator to control
air pressure at each work station, if the supply
pressure is high.
• Ideally the air supply should be free from
moisture. To facilitate removing moisture
from air supply, the installation of a
refrigerated air dryer after the compressor
and the use of drain valves at each
tool station is recommended.
All Dynabrade motors use the highest quality parts and metals available and are machined to exacting tolerances. The failure of quality pneumatic motors can
most often be traced to an unclean air supply. Air pressure easily forces dirt or water contained in the air supply into motor bearings causing early failure. Dirt
and water often score the inner workings of the tool resulting in limited efficiency and power. Our warranty obligation is contingent upon proper use of our
tools and cannot apply to equipment which has been subjected to misuse such as unclean air, wet air or a lack of maintenance during the use of this tool.
Following the reasonable assumption that any inherent defect which might prevail in a product will become apparent to the user within one year from the
date of purchase, all equipment of our manufacture is warranted against defects in workmanship and materials under normal use and service. We shall
repair or replace at our factory, any equipment or part thereof which shall, within one year after delivery to the original purchaser, indicate upon our
examination to have been defective. Our obligation is contingent upon proper use of Dynabrade tools in accordance with factory recommendations,
instructions and safety practices. It shall not apply to equipment which has been subject to misuse, negligence, accident or tampering in any way so as to
affect its normal performance. Normally wearable parts such as bearings, contact wheels, rotor blades, etc., are not covered under this warranty.
MAINTENANCE INSTRUCTIONS - CONTINUED
Air System
Regulator
Closed Loop Pipe System
(Sloped in the direction of air flow)
To Tool Station
Ball
Valve
Drain
Valve
PSIG @ Air Tool
90 PSIG MAX
Notice
One Year Warranty
Regulator
Filter
➤
Drain
Air Hose
Valve
(6.2 Bar)
Drain Valve
3
Air Flow
Refrigerated
Air Dryer
Ball
Valve
Air Flow
Air Compressor
and Receiver