Daylab Daylab 35 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Stampante Daylab Daylab 35. Daylab Daylab 35 17. Slide printer for polaroid

Stampa la pagina

Exposing the film

1 Set the film-type selection switch at the

setting appropriate for the type of film

you are using. See

Setting

controls.

2 Set the exposure-adjustment dial at the

setting appropriate for your slide. For a

slide image with average lighting

conditions, start with the (0) setting.

3 Set the VIEW-OFF-PRINT switch at PRINT.

4 Set the color filtration controls at the

appropriate settings for your slide. You

should initially set the 3 color-filtration

controls at "0".

5 To expose the film, first close the

image-preview door (11). Then gently

pull the dark slide out of the film holder

as far as it will go.

6 Wait approximately 15 seconds for the

ready-indicator light to turn green. Then

press the START button to fire the flash

that exposes the film. Press the button

gently. The slightest vibration to the

Daylab 35 can blur your printed image.

7 After exposing the film, gently insert the

dark slide/viewing panel back into the fiIm

holder, as far as it can go.

Processing the film

Pull the leader tab: Grasp the white

leader tab, and pull it straight, all the way

the exposure

out of the film holder (12). This causes a

second white tab, a larger processing tab

with arrows (12p), to appear. If no

processing tab appears, follow the

instructions in if no processing tab

appears when you pull the leader tab.

Pull the processing tab:

processing tab firmly in the center and

pull it straight, in one smooth continuous

motion, at moderate speed, all the way

out of the film holder (13).

timing immediately. Press the

film-processing-timer button on the front

of the Daylab 35. When you press the

button, the film-processing-timer

indicator starts to glow. Do not disturb

the print while the image is developing.

Wait until the Daylab 35 beeps (4 times),

indicating the preset development time

has elapsed (the timer indicator stops

glowing).

Note: Refer to

controls for

the three preset development times.

These times are set for film development

at room temperature (70°F/21°C) When

developing the film above or below room

temperature, check your film instructions

for the development time recommended

for that temperature, and use the

exposure-adjustment dial to make any

exposure adjustments.

After the full development time, separate

the print from the negative, starting at the

corner nearest the processing tab (14).

Do not let the print drop back onto the

damp negative. (See

this section).

Grip the

The picture is now developing, so start

Setting the exposure

detailed information about

Caution

at the end of