Hi-Tech Diamond All-U-Need Rock/Mineral Manuale di istruzioni - Pagina 14

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander Hi-Tech Diamond All-U-Need Rock/Mineral. Hi-Tech Diamond All-U-Need Rock/Mineral 16.

Stampa la pagina

What lubricants should I use with the

All-U-Need?

We recommend using only clean water with

the All-U-Need. If desired, you may add a water

soluble coolant to the water.

Can I reuse water for diamond

grinding?

You can, but we don't recommend this. When you

reuse water, you risk getting contamination on

your diamond discs which increases the chances

of unwanted scratches on your work pieces. For

best results, use clean water every time you use

the All-U-Need.

How do I clean the white catch tray?

To prevent the drain tube from clogging, flush

the white catch tray after every use on the All-

U-Need by taking a small bucket of clean water

and pouring the water into the catch tray so the

leftover rock sediment gets flushed down the

drain tube. Once you see all of the sediment

gone and the white catch tray is clean, your

All-U-Need will be ready for the next use. If you

need to remove the white catch tray for further

cleaning, do so by removing the arbor with the

Allen wrench that is included with the All-U-Need

instruction manual.

What is the clear tube attached to the

arbor for?

The clear tube attached to the silver arbor helps

prevent water from getting into the motor. The

All-U-Need is designed in such a way that water

should never get into the motor if properly used,

but this is another solution in preventing this

from happening.

FAQS

Can I reuse backing plates that are

backed to used, old smoothing discs,

polishing pads and diamond lap discs?

Yes. Purchasing new backing plates for new

smoothing discs, polishing pads and diamond

laps is not required, if you can properly remove

them from the backing plate. To remove diamond

smoothing discs and polishing pads from backing

plates, simply heat the surface of the diamond

smoothing disc using a heat source from a hair

dryer or heat gun. This takes approximately

2-3 minutes. Peel off the disc from the backing

plate. If there is residual glue stuck on the

backing plate, take a razor blade and scrape it

off. To remove diamond lap discs, which are the

electroplated diamond discs, use the same heat

process as above and use a screwdriver to prop

off the disc from the backing plate. Note: If for

some reason you can't remove all of the residual

glue from the backing plate, we recommend

purchasing a new backing plate. If the surface

on the backing plate is not fully clean or smooth,

this may cause new discs, pads or laps to not stick

properly or lay flat on the backing plate surface,

causing unwanted bumps and grooves on your

work pieces.

Do you sell electrical spare parts for

my All-U-Need? Whom do I contact if

I need a repair or replacement for my

All-U-Need?

Due to the technical nature of our machines,

we do not offer electrical spare parts for you to

install yourself such as motors, speed controllers,

rectifiers, etc. Instead, we offer a repair

service that is done in-house by our qualified

technicians. For more information about our

repair service, visit hitechdiamond.com/repairs.