Hi-Tech Diamond SLANT CABBER Istruzioni per l'uso

Sfoglia online o scarica il pdf Istruzioni per l'uso per Sander Hi-Tech Diamond SLANT CABBER. Hi-Tech Diamond SLANT CABBER 3.

OPERATING INSTRUCTIONS FOR SLANT CABBER

Copper water feed tube

Washer

Flange Knob with

½" Arbor

The flange knob screws into it

Newer model

without copper tube

Introduction

The slant cabber is used to shape and polish cabochons like the wheel grinder. The advantage of the

slant cabber is you can polish a flat surface. The disadvantage is to change grits you have to clean the

disc you are using and mount the disc with the next grit you want to use

Due to the time between the purchases of our slant cabbers there is a slight difference between the two

models. The slant cabber consists of the blue base, a black shield and six discs with backing plates.

General Information:

1. The slant cabber uses discs that have diamonds impregnated on one flat side. These discs may

be made out of steel or a heavy paper.

2. The discs have to be mounted on a backing plate. The backing plate is a black molded composite

disc with a 1/2" arbor hole. The backing plate is required for the disc to fit the slant cabber

properly. If the disc you want to use does not have a backing plate, or if you contact a trainer or

workshop supervisor.

3. The Society has six discs. Three Grinding/Shaping discs with 80, 180, 325 grits (also called mesh)

and three Sanding/Polishing discs wit6h 600, 1,200 and 3,000 grits.

Set up for use:

1. Place a vinyl table cover on a table near a floor outlet where the slant cabber will be set up.

2. This equipment is light and can be carried by one person. Take the slant cabber and box of discs

off a rolling cart and place them on the table.

3. Place a waste bucket on the floor. Insert one end of the waste water drain tube into the short

tube on the side of the machine and the other end in the bucket. Make sure that the drainage

tube is clear of all blockages.

4. Install the disc shield on the machine. One edge of the shield is only about 1/4" high and the

other three edges are about 3/4" high. Slide the 1/4" edge between the arbor and the water

Created 03/29/2016, Revised 11/01/2017

The Villages® Gem & Mineral Society

Water feed control knob

Page 1 of 3

Water supply reservoir

On/Off and speed control knob

Disc Shield

Waste water reservoir

Waste water drain tube.

Make sure to place end of

tube in a small bucket

before filling the supply

tank with water