Hi-Tech Diamond Slant Cabber Glass/Crystal Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander Hi-Tech Diamond Slant Cabber Glass/Crystal. Hi-Tech Diamond Slant Cabber Glass/Crystal 16.

Stampa la pagina

OPERATING INSTRUCTIONS

Carefully unpack the Slant Cabber from

the box and remove all loose foam and

accessories. Set the packaging aside should

you need it in the future. Check to make sure

all parts are present on both the machine and

in the accessory kit. If you find any missing or

damaged parts, call us immediately at 1 (630)

596-9909 or email us at sales@hitechdiamond.

com. Place the Slant Cabber on a table or surface

that is flat in a well lit location. Make sure the

machine sits level.

Set up the water system by inserting the clear

drain tube into the fitting located on the right

side of the machine. Place the other end of the

tube into a bucket (not included). Fill the top water

reservoir with clean water. Adjust the flexible

modular water tube to the center of the disc (Fig.

A). This allows the water to spread evenly across

the surface of the discs while they spin. Never

re-use water. Note: To install the optional Pro-Flow

water cooling system, see page 11.

Top water reservoir

Included in the Slant Cabber accessory kit

are four nickel-electroplated diamond discs,

one Tech-10 polishing pad, one 2-gram diamond

paste syringe and one acrylic backing plate. To

determine what disc you need to start with, see

page 8. To properly install your discs, place the

Centered

water tube

Fig. A

Knurled knob

& washers

backing plate onto the arbor (Fig. B). The backing

plate has a 1/2" arbor hole which fits snug onto

the lip of the arbor. Next, place the diamond disc

on top of the backing plate, making sure the 1/2"

arbor hole in the disc and the 1/2" arbor hole in

the backing plate are centered. Secure the disc

and backing plate with the ¼"-20 thread knurled

knob and washers (Fig. B). Make sure the disc has

even contact with the backing plate surface. Note:

Always use a backing plate for diamond discs or

polishing pads on the Slant Cabber.

Put on safety goggles (not included) and

turn the power switch on. Use the black

water control valve located on the centered

water tube to control the water flow on and off.

You only need a few constant drops of water to

lubricate the discs. Do not use wipers or sponges,

as they may become contaminated with larger

diamond particles. IMPORTANT NOTE: If water

isn't coming out of the water tube after

twisting the water control valve on, refer to

Troubleshooting on page 15.

The arbor may be adjusted up and down

using the included Allen wrench to keep the

discs below the black spray shield. See page 10

for arbor adjustment instructions.

Arbor

Fig. B