Hi-Tech Diamond 31-000 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Sega Hi-Tech Diamond 31-000. Hi-Tech Diamond 31-000 16. 10" slab saw

OPERATING INSTRUCTIONS

Replace the saw table. Insert the black spray

shield (part #8) into the two slots located at

the front of the saw table (Fig. C). The spray shield

can be inserted in either direction.

Before turning your slab saw on, manually

spin the saw blade towards you to make sure

the blade is not in contact with the saw table.

If there is contact, see page 11 for instructions

on how to position the saw blade for clearance.

Note: Some saw blades tend to wave side to side as

you spin them. They typically straighten out after

turning the machine on.

Put on safety goggles (not included), then

turn on the machine by turning the power

switch to the on position. Note: Cutting speed

depends on the type of saw blade you are using.

Never exceed the saw blade's maximum rpm.

Fig. C

There should be a fine mist coming from your

saw blade while it spins. If there isn't, pour

additional water over the blade until there is a

mist. Note: In use, always make sure the saw blade

is properly lubricated. Never run dry.

After each use, turn off the machine, then

unplug your slab saw from its power source.

Drain the water reservoir be removing the drain

plug. Dry the machine and saw blade with paper

towels or a cloth. You may also spin dry the saw

blade by running it on the slab saw until it is

completely dry. Notes: Always dry your saw blade

after each use to prevent rusting. Keep out of reach

of children.