Hi-Z Antennas Hi-Z 8A-80 Manuale - Pagina 7

Sfoglia online o scarica il pdf Manuale per Antenna Hi-Z Antennas Hi-Z 8A-80. Hi-Z Antennas Hi-Z 8A-80 14. 160/80 meters 200/100 foot diameter circle, a models have the pre-amp external level1 plus amps, level2 with plus6 amps

Stampa la pagina

The controller has 5 directional control connections plus a ground and +13.8V supply terminal. It is highly

recommended that you use a good copper round wire in addition to the coax shield to reduce DC voltage drop to

the controller. For runs up to 500 feet a control cable of #16 or #17 wire are adequate. Actually the control lines can

be smaller gauge, but the DC wires must be larger. Number 18 gauge or similar would be adequate for the

direction control lines

CONNECTIONS

13.8VDC

Between

Shack Switch

Phase Controller

The control cable should be connected between the shack switch and the controller connections as seen below.

The supplied delay cables (SHORT, LONG) should be connected to "Short Delay" connectors and the "Long

Delay" connectors on the phase controller.

Array power is supplied through the array power connector. This allows the front panel toggle switch on the

front panel of the shack switch to switch the entire array on and off. The +13.8 terminal is used for sending power

out the control cable to the controller in the center of the array.

There is a 2 foot RG6 cable and 2 foot wire with fork lugs supplied with system. The 2 foot RG6 cable connects

from the Phase Controller Output to the Input of the 75Ω Pre-amp. Connect one end of the 2 foot wire to +13.8VDC

Hi-Z 8A Element Man. 3.0

GNND

CTRL1

Rear View – Shack Switch

Shack Switch

CTRL2

CTRL3

CTRL4

CTRL5