HiB 46800 Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Arredamento per interni HiB 46800. HiB 46800 4. Led illuminated steam free cabinets

Please Note You may need to remove the door(s) to aid installation. This can be done by unclipping the hinges. (There is

a release catch at the back of the hinge see fig.A). Once detached, gently extract the wire between the carcass and the

top of the door then disconnect the cable connector(s) (fig.B). DO NOT FIT SHELVES AT THIS STAGE. Extra care must be

taken when handling cabinets with mirrored sides or diffusers, especially when picking up and putting down the cabinet

- do not pick up the cabinet by the diffusers.

Bracket clip (Fig A)

REAR VIEW

Mounting Points

location of internal

ﬁxing hole

Fixing Preparation (Fig C)

Fixing Brackets (Fig D)

Wall Hung Installation

1. Position the cabinet in a suitable location

(according to the zonal diagram (Fig 1) on the

back page) ensuring that the mains supply

cable is within reach of the cable connection

point of the cabinet. Carefully mark the desired

position of the cabinet using a soft pencil,

ensuring it is level.

2. Remove the cabinet from the wall and using

a spirit level, mark a horizontal line below the

pencil mark, taking into account the location of

the mounting points (Fig. C). Place brackets on

the pencil line paying attention to the distance

between the hangers on the cabinet. Carefully

Wire connectors (Fig B)

Angle Adjustment

Claw In/Out

Adjustment

Hanger Adjustment (Fig E)

mark the position of the holes using a soft

pencil. (Fig. D).

3. Before drilling, ensure there are no hidden

cables or pipes behind the mounting points.

Using a suitable drill bit, drill holes in the

marked positions to a suitable depth.

4. Insert wall plugs level with the surface of the

wall. If fitting to a tiled surface, wall plugs

should be inserted below the tile surface to

avoid cracking. NB. For plasterboard walls,

specialist fixings should be purchased from any

DIY or hardware store.

5. Fix the brackets to the wall using the screws

provided.

6. Carefully remove the small screws along the