HiB 48600 Istruzioni per il montaggio - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Arredamento per interni HiB 48600. HiB 48600 4. Bluetooth cabinets
Anche per HiB 48600: Manuale (2 pagine)

Stampa la pagina

REAR VIEW

Mounting Points

Location of internal

xing hole (SINGLE DOOR)

Location of internal

xing hole (DOUBLE DOOR)

Fixing Preparation (Fig A)

Fixing Brackets (Fig B)

Wall Hung Installation

Ensure the domestic electrical mains supply to which

the cabinet is being connected is turned off.

Position the cabinet in a suitable location

(according to the zonal diagram (Fig 1) on the

back page) ensuring that the mains supply cable is

within reach of the cable connection point of the

cabinet. Carefully mark the desired position of the

cabinet using a soft pencil, ensuring it is level.

Remove the cabinet from the wall and using a

spirit level, mark a horizontal line below the pencil

mark, taking into account the location of the

mounting points (Fig. A). Place brackets on the

line paying attention to the distance between the

hangers on the cabinet. Carefully mark the position

of the holes using a soft pencil. (Fig. B).

Before drilling, ensure there are no hidden cables

or pipes behind the mounting point. Using a

suitable drill bit, drill holes in the marked positions

to a suitable depth.

Insert wall plugs level with the surface of the wall.

If fitting to a tiled surface, wall plugs should be

inserted below the tile surface to avoid cracking.

NB. For plasterboard walls, specialist fixings should be

purchased from any DIY or hardware store.

Fix the brackets to the wall using the screws

provided.

Carefully remove the small screws along the top

front edge of the cabinet to gain access to the

internal panel(s). (Fig. C) Keep screws in a safe

place.

Temporarily hang the cabinet ensuring the claws

on the hangers are securely located on the wall

brackets. Using a spirit level adjust the cabinet via

the screws on the hangers. (Fig. C).

Mark the position of the internal fixing hole and

remove the cabinet. Using a suitable drill bit, drill a

Hanger Adjustment (Fig C)

hole and insert a wall plug as per stage 4 above.

Connect the cable at the rear of the cabinet to the

mains supply cable using a suitable terminal block

(not supplied) according to the wiring diagram (Fig.

2) on the back page.

10. Rehang the cabinet in position, tighten the screws

on the hangers (Fig. C) and secure the base of the

Move door(s) up/down

cabinet with the supplied screw(s) and screw cap(s).

11. Switch the mains supply back on.

Move door away/towards

Move door(s) up/down

the cabinet

Move door(s) left/right

Move door away/towards

the cabinet

Move door(s) left/right

Door Adjustment (Fig D)

Operation Instructions

To turn illumination on, touch the sensor once (Fig.E).

To change the colour temperature, touch and hold the

sensor until desired colour is obtained. The colour temp

is then set until changed again.

Heated Pad is only on when cabinet is illuminated.

Angle Adjustment

Claw In/Out

Adjustment

Move door(s) up/down

Move door away/towards

the cabinet

Move door(s) left/right

Move door(s) up/down

Move door away/towards

the cabinet

Move door(s) left/right